Exhaust regulations and improved exhaust gas treatment systems have already initiated the trend that brings emissions from brakes and tires to the forefront of traffic-induced particulate matter. The health and environmental relevance of particulate matter has resulted in regulators, industry, and research institutions prioritising the mitigation of non-exhaust particle emissions. To this end, under the umbrella of the United Nations Economic Commission for Europe World Forum for Harmonisation of Vehicle Regulations (UNECE WP.29), the Working Party on Pollution and Energy (GRPE) mandated the Particle Measurement Programme Informal Working Group (PMP-IWG) to develop a Global Technical Regulation (GTR) for measuring brake dust. The standards and procedures defined within the GTR should eventually form the basis for the introduction of a Euro 7 limit value for brake emissions. The purpose of this measurement campaign is to provide an exemplary overview of the emission behaviour of wheel brakes and friction pairings currently available on the market and to identify possible reduction potential with regard to particulate emissions. All measurements were carried out taking into account the draft GTR valid at the time of execution. For the investigations, brakes were selected using the example of different vehicle classes, brake concepts (disc and drum brake), vehicle axles (front and rear axle), and alternative friction materials (brake disc and pads/shoes). Thus, the use of wear-resistant discs and improved brake pad compositions are able to achieve significantly lower emissions. In addition, the measurement of brake dust emissions from vehicles with different levels of electrification was considered. Electrical braking was modelled and applied to the Worldwide Harmonised Light-Duty Vehicles Test Procedure (WLTP) Brake Cycle, which has demonstrated high emission reduction potentials depending on the electrification level.

Traffic-related emissions are strongly criticised by the public because they contribute to climate change and are classified as hazardous to health. Combustion engine emissions have been regulated by limit values for almost three decades. There is currently no legal limit for non-exhaust emissions, which include tire wear particle emissions and resuspension. As a result, the percentage of total vehicle emissions has risen continuously. Some of the particles emitted can be assigned to the size classes of particulate matter (≤10 µm) and are therefore of particular relevance to human health. The literature describes a wide range of concepts for sampling and measuring tire wear particle emissions. Because of the limited number of studies, the mechanisms involved in on-road tests and their influence on the particle formation process, particle transport and the measuring ability can only be described incompletely. The aim of this study is to compare test bench and on-road tests and to assess the influence of selected parameters. The first part describes the processes of particle injection and particle distribution. Based on this, novel concepts for sampling and measurement in the laboratory and in the field are presented. The functionality and the mechanisms acting in each test environment are evaluated on the basis of selected test scenarios. For example, emissions from external sources, the condition of the road surface and the influence of the driver are identified as influencing factors. These analyzes are used to illustrate the complexity and limited reproducibility of on-road measurements, which must be taken into account for future regulations.

This article deals with methods and measurements related to environmental pollution and analysis of particle distribution in urban and suburban landscapes. Therefore, an already-invented sampling method for tyre road wear particles (TRWP) was used to capture online emission factors from the road. The collected particles were analysed according to their size distribution, for use as an input for particle distribution simulations. The simulation model was a main traffic intersection, because of the high vehicle dynamic related to the high density of start–stop manoeuvres. To compare the simulation results (particle mass (PM) and particle number (PN)) with real-world emissions, measuring points were defined and analysed over a measuring time of 8 h during the day. Afterwards, the collected particles were analysed in terms of particle shape, appearance and chemical composition, to identify the distribution and their place of origin. As a result of the investigation, the appearance of the particles showed a good correlation to the vehicle dynamics, even though there were a lot of background influences, e.g., resuspension of dust. Air humidity also showed a great influence on the recorded particle measurements. In areas of high vehicle dynamics, such as heavy braking or accelerating, more tyre and brake particles could be found.