Our ability to interpret seismic observations including the seismic discontinuities and the density and velocity profiles in the earth's interior is critically dependent on the accuracy of pressure measurements up to 364 GPa at high temperature. Pressure scales based on the reduced shock-wave equations of state alone may predict pressure variations up to 7% in the megabar pressure range at room temperature and even higher percentage at high temperature, leading to large uncertainties in understanding the nature of the seismic discontinuities and chemical composition of the earth's interior. Here, we report compression data of gold (Au), platinum (Pt), the NaCl-B2 phase, and solid neon (Ne) at 300 K and high temperatures up to megabar pressures. Combined with existing experimental data, the compression data were used to establish internally consistent thermal equations of state of Au, Pt, NaCl-B2, and solid Ne. The internally consistent pressure scales provide a tractable, accurate baseline for comparing high pressure–temperature experimental data with theoretical calculations and the seismic observations, thereby advancing our understanding fundamental high-pressure phenomena and the chemistry and physics of the earth's interior.
We have determined the postspinel transformation boundary in Mg2SiO4 by combining quench technique with in situ pressure measurements, using multiple internal pressure standards including Au, MgO, and Pt. The experimentally determined boundary is in general agreement with previous in situ measurements in which the Au scale of Anderson et al. [1989] was used to calculate pressure: Using this pressure scale, it occurs at significantly lower pressures compared to that corresponding to the 660‐km seismic discontinuity. In this study, we also report new experimental data on the transformation boundary determined using MgO as an internal standard. The results show that the transition boundary is located at pressures close to the 660‐km discontinuity using the MgO pressure scale of Speziale et al. [2001] and can be represented by a linear equation, P(GPa) = 25.12 − 0.0013T(°C). The Clapeyron slope for the postspinel transition boundary is precisely determined and is significantly less negative than previous estimates. Our results, based on the MgO pressure scale, support the conventional hypothesis that the postspinel transformation is responsible for the observed 660‐km seismic discontinuity.
The boundary layer between the crystalline silicate lower mantle and the liquid iron core contains regions with ultralow seismic velocities. Such low compressional and shear wave velocities and high Poisson's ratio are also observed experimentally in post-perovskite silicate phase containing up to 40 mol% FeSiO 3 endmember. The iron-rich post-perovskite silicate is stable at the pressure-temperature and chemical environment of the core-mantle boundary and can be formed by core-mantle reaction. Mantle dynamics may lead to further accumulation of this material into the ultralow-velocity patches that are observable by seismology.