In the present paper, the energy performance of buildings forming a school centre in the northwest of Spain was analyzed using a transient simulation of the energy model of the school, which was developed with TRNSYS, a software of proven reliability in the field of thermal simulations. A deterministic calibration approach was applied to the initial building model to adjust the predictions to the actual performance of the school, data acquired during the temperature measurement campaign. The buildings under study were in deteriorated conditions due to poor maintenance over the years, presenting a big challenge for modelling and simulating it in a reliable way. The results showed that the proposed methodology is successful for obtaining calibrated thermal models of these types of damaged buildings, as the metrics employed to verify the final error showed a reduced normalized mean bias error (NMBE) of 2.73%. It was verified that a decrease of approximately 60% in NMBE and 17% in the coefficient of variation of the root mean square error (CV(RMSE)) was achieved due to the calibration process. Subsequent steps were performed with the aid of new software, which was developed under a European project that enabled the automated calibration of the simulations.

In this study, an experimental approach was utilized to assess the viability of three biomass fuels in a small laboratory-scale combustor. Three feedstocks currently considered as residues were selected based on their widespread presence in the Euroregion Galicia-North Portugal, and some were modified to improve their behavior by removing fine particles or adding substances to increase the melting point of the ashes. The experimental facility was a highly modifiable, fixed-bed combustor with air-staging capabilities and a wide array of sensors intended to measure a large quantity of parameters. A series of tests was performed to cover the widest range of total air flows possible for the facility, with values of 0.223, 0.279 and 0.334 kg/m²s being used, while 30% of the total air flow enters from below the combustion bed and 70% over it. Results from the proximate and elemental analyses show high proportions of ash in every fuel compared to commercial wood pellets, and empirical deposition indexes suggest a high risk of fouling and slagging. Testing confirmed the analysis predictions, resulting in the kiwi- and vine-based fuels not being suitable for a facility without ash elimination systems. Some modifications of the gorse fuel showed improved behavior compared to unmodified gorse fuel, namely, the addition of a 2% mass fraction of CaCO₃ and the removal of fine particles. The former prevented ash sintering, and the latter greatly decreased the fouling of the heat exchanger tubes. These results suggest that some of the vegetal species studied might be suitable for their use in small-scale biomass burners, and besides the accuracy of one of the deposition indexes used is confirmed.

The increasing use of biomass combustion systems as household appliances for heat generation is causing concern about local air quality. Areas with high concentrations of particulate matter (PM) emissions are linked to health risks. There is a need for a removal device that collects the particles before they reach the atmosphere. Electrostatic precipitators (ESPs) are the most suitable option. In this study, a laboratory-scale prototype ESP was tested with a pellet boiler. Retention efficiencies above 90% were obtained with three different discharge electrode dispositions. The continuous operation of the ESP was achieved with a dynamic control system despite fluctuations in emissions, gas conditions, etc. The accumulation of particles on inner ESP surfaces over the operation time reduced the effectiveness of the electric field, and thus retention efficiency. In this study, the retention efficiency fell from 90% to 31% in 34 h.