Strong wind disturbances can affect large forested areas and often occur irregularly within a forest. Due to this, identifying damaged sites and estimating the extent of these losses are crucial for the harvesting management of salvage logging. Furthermore, the location should be surveyed as soon as possible after the disturbance to prevent the degradation of fallen trees. A fixed-wing type of unmanned aircraft system (UAS) with a compact digital camera was used in this study. The imagery was acquired on approximately 200 hectares where five large windthrow areas had occurred. The objective of the study was to determine the location of the windthrow areas using a semi-automatic approach based on the UAS imagery, and on the combination of UAS imagery with airborne laser scanning (ALS). The results were compared with reference data measured by global navigation satellite system (GNSS) devices. At the same time, windthrow areas were derived from Landsat imagery to investigate whether the UAS imagery would have significantly more accurate results. GNSS measurements and Landsat imagery are currently used in forestry on an operational level. The salvage logging was estimated for each forest stand based on the estimated areas and volume per hectare obtained from the forest management plan. The results from the UAS (25.09 ha) and the combined UAS/ALS (25.56 ha) methods were statistically similar to the reference GNSS measurements (25.39 ha). The result from Landsat, at 19.8 ha, was not statistically similar to the reference GNSS measurements or to the UAS and UAS/ALS methods. The estimate of salvage logging for the whole area, from UAS imagery and the forest management plan, overestimated the actual salvage logging measured by foresters by 4.93% (525 m³), when only the most represented tree species were considered. The UAS/ALS combination improved the preliminary results of determining windthrow areas which lead to decreased editing time for all operators. The UAS imagery shows potential for application to early-stage surveys of windthrow areas in forests. The advantages of this method are that it provides the ability to conduct flights immediately after the disturbance, the foresters do not need to walk within the affected areas which decreases the risk of injury, and allows flights to be conducted on cloudy days. The orthomosaic of the windthrow areas, as a by-product of data processing in combination with forest maps and forest road maps, can be used as a tool to plan salvage logging.

Proper knowledge about resources in forest management is fundamental. One of the most important parameters of forests is their size or spatial extension. By determining the area of treefall gaps inside the compartments, a more accurate yield can be calculated and the scheduling of forestry operations could be planned better. Several field- and remote sensing-based approaches are in use for mapping but they provide only static measurements at high cost. The Earth Observation satellite mission Sentinel-2 was put in orbit as part of the Copernicus programme. With the 10-m resolution bands, it is possible to observe small-scale forestry operations like treefall gaps. The spatial extension of these gaps is often less than 200 m², thus their detection can only be done on sub-pixel level. Due to the higher temporal resolution of Sentinel-2, multiple observations are available in a year; therefore, a time series evaluation is possible. The modelling of illumination can increase the accuracy of classification in mountainous areas. The method was tested on three deciduous forest sites in the Börzsöny Mountains in Hungary. The area evaluation produced less than 10% overestimation with the best possible solutions on the sites. The presented work shows a low-cost method for mapping treefall gaps which delivers annual information about the gap area in a deciduous forest.