In our study, the effect of the use of autofluorescence (Visually Enhanced Lesion Scope—VELscope) on increasing the success rate of surgical treatment in oral squamous carcinoma (OSCC) was investigated. Our hypothesis was tested on a group of 122 patients suffering from OSCC, randomized into a study and a control group enrolled in our study after meeting the inclusion criteria. The preoperative checkup via VELscope, accompanied by the marking of the range of a loss of fluorescence in the study group, was performed before the surgery. We developed a unique mucosal tattoo marking technique for this purpose. The histopathological results after surgical treatment, i.e., the margin status, were then compared. In the study group, we achieved pathological free margin (pFM) in 55 patients, pathological close margin (pCM) in 6 cases, and we encountered no cases of pathological positive margin (pPM) in the mucosal layer. In comparison, the control group results revealed pPM in 7 cases, pCM in 14 cases, and pFM in 40 of all cases in the mucosal layer. This study demonstrated that preoperative autofluorescence assessment of the mucosal surroundings of OSCC increased the ability to achieve pFM resection 4.8 times in terms of lateral margins.

The objective of this study was to compare the distribution of stress in the maxillary bone, dental implants, and prosthetic components supporting implant-supported maxillary overdentures with partial palatal coverage, in both splinted and unsplinted designs. Two models of maxillary overdentures were designed using the Exocad Dental CAD program, which included cancellous and cortical bone. The complete denture design and abutments (locator abutments in the unsplinted and Hader bar with Vertix attachments placed distally in the splinted variant) were also designed. The denture material was PEEK (Polyetheretherketone), and the method used to analyze patient-specific 3D X-ray scans was 3D QCT/FEA (three-dimensional quantitative computed tomography-based finite element analysis). Loading was divided into three load cases, in the frontal region (both incisors of the denture) and distal region (both molars and first premolar of the denture). The forces applied were 150 N with an oblique component with a buccal inclination of 35° in the frontal region, and 600 N with a buccal inclination of 5° (molars) or solely vertical (premolar) in the distal region. The model with locator abutments showed higher stresses in all load cases in both analyzed implant variants and in the maxilla. The differences in stress distribution between the splinted and unsplinted variants were more significant in the distal region. According to the results of the present study, the amount of stress in bone tissue and dental implant parts was smaller in the splinted, bar-retained variant. The findings of this study can be useful in selecting the appropriate prosthetic design for implant-supported maxillary overdentures with partial palatal coverage.

The influence of preoperative examination of oral squamous cell carcinoma (OSCC) mucosal surrounding by VELscope (Visually Enhanced Lesion Scope) on the radicality of surgical treatment of OSCC was the goal of this study.It is the first analysis of its kind with a total number of 122 patients suffering from OSCC with homogenous distribution of different tumor stages randomized into a study and a control group and enrolled in our study after meeting the inclusion criteria. The preoperative checkup by VELscope accompanied by the marking of the range of a loss of fluorescence in the study group was performed before the surgery. We have developed a unique mucosal tattoo marking technique for this purpose. The pathohistological results after surgical treatment, i.e. the margin status, were then compared. We achieved the pathological free margin (pFM) in 55 patients, the pathological close margin (pCM) in 6 cases and we encountered no case of the pathological positive margin (pPM) in the mucosal layer in the study group. In comparison, the control group results revealed pPM in 7 cases, pCM in 14 cases and pFM in 40 of all cases in the mucosal layer. This study proved that the preoperative autofluorescence evaluation of a tumor mucosal surrounding can enhance the ability to reach the pFM resection.

Chronic inflammation in the oral cavity has a negative effect on the course of chronic mucosal lesions. The present study aimed to compare the volume and proportional presence of aggressive periodontal pathogens in patients with oral lichen planus (OLP) accompanied by desquamative gingivitis (DG) vs. those with OLP without gingival involvement. All patients in the cohort were also diagnosed with moderate chronic periodontitis. The observed differences may help explain the higher risk associated with gingival involvement in OLP. The presence of periodontal pathogens was evaluated in 50 biopsy-confirmed OLP with DG cases and 50 OLP cases without gingival manifestations. All participants presented with chronic periodontitis of comparable severity (moderate: periodontal pocket depth (PPD) up to 6 mm). Aggressive periodontal pathogens were identified and quantified using DNA testing (VariOr®-Dento). The periodontal status was assessed using orthopantomography (OPG) or cone-beam computed tomography (CBCT), in combination with the clinical examination of periodontal pockets. In comparison with the non-gingival OLP cases, the OLP cases with gingival involvement exhibited a significantly higher proportional presence of aggressive periodontal pathogens (p = 0.0009) and a higher bacterial load (n/μL; p = 0.001). Desquamative gingivitis associated with OLP was also linked to an increased risk of subsequent periodontal resorption. Given the unstable chronic inflammatory environment, careful monitoring of periodontal tissues in OLP cases appears to be essential, as persistent inflammation may contribute to an elevated risk of malignant transformation. Our findings demonstrate a significant difference in the presence of aggressive periodontal pathogens between OLP cases with and without gingival involvement. The median pathogen volume in the OLP with DG cases was over 7.4 times higher. Chronic inflammation and bacterial by-products may act as cofactors in the development of dysplasia and the malignant transformation of oral lichen with dysplasia (OLD), which may present clinically as DG.

The objective of this study was to compare the distribution of stress in the maxillary bone, dental implants, and prosthetic components supporting implant-supported maxillary overdentures with partial palatal coverage, in both splinted and unsplinted designs. Two models of maxillary overdentures were designed using the Exocad Dental CAD program, which included cancellous and cortical bone. The complete denture design and abutments (locator abutments in the unsplinted and Hader bar with Vertix attachments placed distally in the splinted variant) were also designed. The denture material was PEEK (Polyetheretherketone), and the method used to analyze patient-specific 3D X-ray scans was 3D QCT/FEA (Three-dimensional Quantitative Computed Tomography-Based Finite Element Analysis). Loading was divided into three load cases: frontal region (both incisors of the denture) and distal region (both molars and first premolar of the denture). The forces applied were 150 N with an oblique component with a buccal inclination of 35° in the frontal region, and 600 N with a buccal inclination of 5° (molars) or solely vertical (premolar) in the distal region. The model with locator abutments showed higher stresses in all load cases in both analyzed implant variants and in the maxilla. The differences in stress distribution between the splinted and unsplinted variants were more significant in the distal region. According to the results of the present study, the amount of stress in bone tissue and dental implant parts was smaller in the splinted, bar-retained variant. The findings of this study can be useful in selecting the appropriate prosthetic design for implant-supported maxillary overdentures with partial palatal coverage.

Background: Saliva sampling is increasingly used for respiratory virus diagnostics in dentistry and oral medicine due to patient comfort and reduced exposure risk. How routine behaviors—mechanical oral hygiene, rinsing, and food intake—affect short-term SARS-CoV-2 detectability remains insufficiently characterized for clinical workflows. Methods: In this international two-center pilot study, twelve RT-PCR-confirmed COVID-19 patients provided paired mouth-rinse saliva samples and pharyngeal swabs at predefined time points. The study assessed (I) an intensified 3 min mechanical oral hygiene protocol (toothbrushing of teeth, gingiva, tongue, and palate, followed by toothpaste–saliva gargling); (II) repeated short mouth rinses; and (III) postprandial sampling. Viral RNA was quantified by RT-PCR; Ct-trajectories were analyzed intra-individually. Results: Cycle threshold (Ct) values from pharyngeal swabs remained relatively stable over time, whereas mouth-rinse samples exhibited notable fluctuations throughout the 24 h period. An average increase of 3 Ct units was observed three minutes after the final mouth rinse (T24+3). Meal ingestion was associated with increased Ct values, rising by 4–5 units for pharyngeal swabs and 3–11 units for mouth rinses immediately after eating. Conclusions: In clinical dental settings, saliva diagnostics are feasible but acutely modulated by common behaviors. Mechanical oral hygiene, brief rinsing, and food intake can transiently reduce detectable oral SARS-CoV-2 RNA, with potential implications for timing of sampling, chairside triage, and infection-control protocols. This pilot study provides initial evidence supporting the development of standardized pre-analytical instructions (e.g., fasting window, pre-rinse policy, and sampling timing relative to oral hygiene and meals) to enhance the reliability of saliva-based testing in dental care.