This paper aimed at comparing different propagation models for the calculation of sound pressure fields in the ocean as well as sound exposure levels. The chosen models are freely available and commonly used by the general underwater acoustics community when sound propagation losses need to be predicted in an ocean environment. The models used were Ocean Acoustics and Seismic Exploration Synthesis (OASES), RAM, Bellhop, and Kraken, which are all based on different approximations of the wave equation. The comparison exercise was carried out by calculating propagation loss, sound pressure waveforms, and sound exposure levels produced by a modeled air gun source. Calculations were performed for a simple range-independent problem of a Pekeris waveguide and produced insights into applicability of each model with regards to near- and far-fields, as well as low and high frequencies for example. Two of the models, RAM and Bellhop, which are suitable to range-dependent problems, were also used to solve a slightly complex case having a sloping bottom. It is hoped that the results presented here will be particularly useful to those who need to use propagation models for marine environmental and bioacoustics studies.
17 October 2014 in The Journal of the Acoustical Society of America
The Centre for Maritime Research and Experimentation conducted a geoacoustic inverse experiment in the Mediterranean Sea in the summer of 2012. Among the objectives was to employ an autonomous underwater vehicle to collect acoustic data to invert for properties of the seafloor. Inversion results for the compression wave speed in the bottom and the source spectrum of the R/V Alliance during a close approach to the bottom moored vehicle are presented. The estimated wave speed was 1529 m/s (σ=10). The source spectrum of the Alliance was estimated across more than six octaves of frequency.
Concern about the impact of sound on marine mammals has increased over the last decade, causing governments to take a more rigorous look at the potential impact of activities that introduce sound into the ocean. Environmental Impact Statements (EIS's) can be prepared using differing analysis methods to estimate the impact on marine mammals. To assess consistency in assessment methods, differences in the base assumptions were investigated; in particular, differences that arise between assumptions of dynamic marine mammals (animat method) and static distributions of marine mammals (static distribution method). Using several ocean environment scenarios and species, it is demonstrated that differences consistently arise between the two methods. The static distribution method underestimates the number of behavioral harassments compared with the animat method. Repeating many simulations with the animat method provides a robust risk assessment, provides a measure of variability, and allows the probability of "spurious events" to be estimated.
13 December 2011 in The Journal of the Acoustical Society of America
Recent work has shown that endfire beamforming of ocean noise can be used to produce images of the seabed layering [Siderius , J. Acoust. Soc. Am.120, 1315–1323 (2006)]. This initial noise imaging technique used conventional beamforming and was later extended to adaptive beamforming that is theoretically optimal. However, there can be problems with adaptive methods, which include extreme sensitivity to random errors, the required averaging time, and computational complexity. Here, the concept of supergain is used to show that delay and sum beamforming can produce nearly the same results as the optimal adaptive methods without the drawbacks.
1 November 2024 in The Journal of the Acoustical Society of America
Models of the underwater acoustic soundscape are important for evaluating the effects of human generated sounds on marine life. The performance of models can be validated against measurements or verified against each other for consistency. A verification workshop was held to compare models that predict the soundscape from wind and vessels and estimate detection ranges for a submerged target. Eight modeling groups participated in the workshop which predicted sound levels with observation windows of 1 min and 1 km2. Substantial differences were found in how modelers computed the propagation losses for decidecade bands and estimated the source level of wind. Further investigations resulted in recommendations on best practices. Choices of temporal and spatial modeling resolution affected the estimates of metrics proportional to total sound energy more than distributions of sound pressure level. Deeper receivers were less sensitive to these parameters than shallow ones. A temporal resolution of 1 min and spatial resolution of 100 m is recommended. Models that follow the recommendations will yield similar results. The detection range of underwater targets is highly variable when the ambient noise depends on moving noise sources. Future work to verify models against data and understand model uncertainty is recommended.