Extending nanostructures into the third dimension has become a major research avenue in modern magnetism, superconductivity, and spintronics, because of geometry-, curvature-, and topology-induced phenomena. Here, we introduce Co–Fe nanovolcanoes—nanodisks overlaid by nanorings—as purpose-engineered 3D architectures for nanomagnonics, fabricated by focused electron beam-induced deposition. We use both perpendicular spin-wave resonance measurements and micromagnetic simulations to demonstrate that the rings encircling the volcano craters harbor the highest-frequency eigenmodes, while the lower-frequency eigenmodes are concentrated within the volcano crater, due to the non-uniformity of the internal magnetic field. By varying the crater diameter, we demonstrate the deliberate tuning of higher-frequency eigenmodes without affecting the lowest-frequency mode. Thereby, the extension of 2D nanodisks into the third dimension allows one to engineer their lowest eigenfrequency by using 3D nanovolcanoes with 30% smaller footprints. The presented nanovolcanoes can be viewed as multi-mode microwave resonators and 3D building blocks for nanomagnonics.
The maximal speed for magnetic flux quanta is determined by the energy relaxation of unpaired electrons and is thus essential for superconducting microstrip single-photon detectors (SMSPDs). However, the deduction of from the current-voltage (-) curves at zero magnetic field is hindered by the unknown number of vortices, , as a small number of fast-moving vortices can induce the same voltage as a large number of slow-moving ones. Here, we introduce an approach for the quantitative determination of and . The idea is based on the Aslamazov and Larkin prediction of kinks in the - curves of wide and short superconducting constrictions when the number of fluxons crossing the constriction is increased by one. We realize such conditions in wide thin strips with slits milled by a focused ion beam and reveal quantum effects in a macroscopic system. By observing kinks in the - curves with increase of the transport current, we evidence a crossover from a single- to multifluxon dynamics and deduce km/s. Our experimental observations are augmented with numerical modeling results, which reveal a transition from a vortex chain over a vortex jet to a vortex river with increase of and . Our findings are essential for the development of one-dimensional and two-dimensional few-fluxon devices and provide a demanded approach for the deduction of maximal vortex velocities at the SMSPD operation conditions.
Magnonics is a rapidly developing domain of nanomagnetism, with application potential in information processing systems. Realisation of this potential and miniaturisation of magnonic circuits requires their extension into the third dimension. However, so far, magnonic conduits are largely limited to thin films and 2D structures. Here, we introduce 3D magnonic nanoconduits fabricated by the direct write technique of focused-electron-beam induced deposition (FEBID). We use Brillouin light scattering (BLS) spectroscopy to demonstrate significant qualitative differences in spatially resolved spin-wave resonances of 2D and 3D nanostructures, which originates from the geometrically induced non-uniformity of the internal magnetic field. This work demonstrates the capability of FEBID as an additive manufacturing technique to produce magnetic 3D nanoarchitectures and presents the first report of BLS spectroscopy characterisation of FEBID conduits.
26 March 2023 in Physica Status Solidi (RRL) – Rapid Research Letters
Superconducting bridges exhibit many properties of a Josephson junction, such as the electromagnetic radiation at overcritical currents and steps in the microwave‐irradiated current–voltage (I–V) curves. These Josephson effects stem from the periodic motion of magnetic flux quanta (vortices) in the narrowest region of the bridge. According to the Aslamazov and Larkin (AL) theory, the I–V curve of such a constriction should exhibit voltage kinks each time the number of vortices in the 1D vortex chain is increased by one. However, in the presence of defects and fluctuations, the intervortex repulsion stipulates the formation of a 2D vortex jet, which goes beyond the 1D AL model. Here, by milling one or two slits across a MoSi thin strip, we make vortices to move in a vortex–jet or a vortex–chain fashion, respectively. Unexpectedly, for the strip with a vortex jet, we observe equidistant voltage kinks at transport currents which are rather far from the assumption of in the AL model. At the moment, we have no explanation for this observation, tending to attribute it to fast relaxation processes in MoSi and looking forward for a comparison with other superconducting materials.