With an ever increasing dependence on electrical energy for powering modern equipment and electronics, research is focused on the development of efficient methods for the generation, storage and distribution of electrical power. In this regard, the development of suitable dielectric based solid-state capacitors will play a key role in revolutionizing modern day electronic and electrical devices. Among the popular dielectric materials, anti-ferroelectrics (AFE) display evidence of being a strong contender for future ceramic capacitors. AFE materials possess low dielectric loss, low coercive field, low remnant polarization, high energy density, high material efficiency, and fast discharge rates; all of these characteristics makes AFE materials a lucrative research direction. However, despite the evident advantages, there have only been limited attempts to develop this area. This article attempts to provide a focus to this area by presenting a timely review on the topic, on the relevant scientific advancements that have been made with respect to utilization and development of anti-ferroelectric materials for electric energy storage applications. The article begins with a general introduction discussing the need for high energy density capacitors, the present solutions being used to address this problem, and a brief discussion of various advantages of anti-ferroelectric materials for high energy storage applications. This is followed by a general description of anti-ferroelectricity and important anti-ferroelectric materials. The remainder of the paper is divided into two subsections, the first of which presents various physical routes for enhancing the energy storage density while the latter section describes chemical routes for enhanced storage density. This is followed by conclusions and future prospects and challenges which need to be addressed in this particular field.

The lithium aluminosilicate system (LAS) is being explored for almost seven decades due to its anomalous and attractive properties (especially low/negative thermal expansion and fast ion conduction) and its commercial significance in consumer as well as strategic sectors. This review introduces current commercial applications of LAS systems, necessary background science, structural features of different LAS crystal systems, including their polymorphs and solid-solutions, and the origin of unusual properties. Significant emphasis is provided on processing transparent, nanocrystalline, low thermal expansion glass-ceramic (LEGC), the role of chemical constituents and additives, the effect of heat-treatment, and microstructural evolution while processing LEGC. Detailed discussions are provided on the following areas: LAS matrix composites, chemical strengthening of glass and glass-ceramic, low temperature co-fired ceramics (LTCC) and associated joining technologies (hydrolysis catalysis bonding, anodic bonding, brazing, etc.) that would further extend the application portfolio of LAS system.

A highly efficient third generation catalyst, CaCu₃Ti₄O₁₂ (CCTO) shows excellent photoelectrochemical (PEC) and photocatalytic ability. As only 4% part of the solar spectrum covers UV light, thus it is highly desirable to develop visible light active photocatalyst materials like CCTO for effective solar energy conversion. A direct band transition with a narrow band gap (1.5 eV) was observed. Under light irradiation, high photocurrent density was found to be 0.96 mA/cm², indicating the visible light induced photocatalytic ability of CCTO. Visible light mediated photocatalytic and photoelectrocatalytic degradation efficiency of CaCu₃Ti₄O₁₂ pellets (CCTO) was investigated for three classes of pharmaceutical waste: erythrosin (dye), ciprofloxacin (antibiotic) and estriol (steroid). It is found that the degradation process follows first order kinetic reaction in electrocatalysis, photocatalysis and photoelectrocatalysis and high kinetic rate constant was observed in photoelectrocatalysis. This was quite high in comparison to previously reported methods.