Metal working fluids are used in machining processes of many hard-to-cut materials to increase tool life and productivity. Thereby, the metal working fluids act on the thermal and on the mechanical loads of the tool. The changing mechanical loads can mostly be attributed to the changing friction between rake face and chip and changes in the chip formation, e.g., the contact length between rake face and chip. However, analyzing those effects is challenging, since a detailed look at the chip formation process is prevented by the metal working fluid. In this paper, a novel planing test rig is presented, which enables high-speed recordings of the machining process and process force measurements while using metal working fluids. Experiments reveal that process forces are reduced with increasing pressure of the metal working fluid. However, the average friction coefficient only changes slightly, which indicates that the reduced process forces are mainly the result of reduced contact lengths between rake face and chip.

The contact length is one of the most important factors to evaluate the chip formation process and the mechanical loads in metal cutting. Over the years, several methods to identify the contact length were developed. However, especially for wet cutting processes the determination of the contact length is still challenging. In this paper, three methods to identify the contact length for dry and wet processes in cutting of Ti6Al4V and AISI4140 + QT are presented, discussed and analyzed. The first approach uses tools with a microtextured rake face. By evaluating the microstructures on the chip, a new method to identify the contact length is established. The second approach applies high speed recordings to identify the contact length. The challenge is thereby the application of high-speed recordings under wet conditions. In the third approach, tools with restricted contact length are used. It is shown that with all three methods the contact length is reduced using metal working fluid.

An understanding of the proper application of metalworking fluids (MWFs) is necessary for their implementation in efficient production processes. In addition, the knowledge of the process-related aspect of chip transport and the macroscopic cooling effect, the characteristics and properties of lubricant film formation, and the cooling conditions in the secondary shear zone on the chip surface, i.e., in the direct vicinity of the material separation, represent a combined fundamental scientific issue within production engineering. The aim is to transfer methods from the field of tribology of machine elements, which have already led to a considerable gain in knowledge in this discipline, to machining and to couple them with already established approaches to machining. In the case of roller bearings, the contact pressure is in the range as the pressure in the contact zone between the cutting insert and chip. Due to this, established methods might be transferred to the cutting process. In addition to classical pin-on-plate and pin-on-ring friction investigations, film thickness measurements were carried out and compared to machining tests. The coefficient of friction determined in the planing test rig is 0.48 for dry cutting, while it is 0.47 for wet cutting. These two values are much larger than the CoF with MWFs measured on the two tribometers. It is shown that the boundary friction of MWF especially influences the machining process. Thus, additives in MWF might have a high significance in machining.

For repairing turbine blades or die and mold forms, additive manufacturing processes are commonly used to build-up new material to damaged sections. Afterwards, a subsequent re-contouring process such as 5-axis ball end milling is required to remove the excess material restoring the often complex original geometries. The process design of the re-contouring operation has to be done virtually, because the individuality of the repair cases prevents actual running-in processes. Hard-to-cut materials e.g. titanium or nickel alloys, parts prone to vibration and long tool holders complicate the repair even further. Thus, a fast and flexible material removal simulation is needed. The simulation has to predict suitable processes focusing shape deviations under consideration of process stability for arbitrary complex engagement conditions. In this paper, a dynamic multi-dexel based material removal simulation is presented, which is able to predict high-resolution surface topography and stable parameters for arbitrary processes such as 5-axis ball end milling. In contrast to other works, the simulation is able to simulate an unstable process using discrete cutting edges in real-time.