Titania nanotube (TNT) coatings were produced using low-potential anodic oxidation of Ti6Al4V substrates in the potential range 3–20 V. They were analysed by X-ray diffraction (XRD), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), and scanning electron microscopy (SEM). The wettability was estimated by measuring the contact angle when applying water droplets. The bioactivity of the TNT coatings was established on the basis of the biointegration assay (L929 murine fibroblasts adhesion and proliferation) and antibacterial tests against Staphylococcus aureus (ATCC 29213). The photocatalytic efficiency of the TNT films was studied by the degradation of methylene blue under UV irradiation. Among the studied coatings, the TiO2 nanotubes obtained with the use of 5 V potential (TNT5) were found to be the most appropriate for medical applications. The TNT5 sample possessed antibiofilm properties without enriching it by additional antimicrobial agent. Furthermore, it was characterized by optimal biocompatibility, performing better than pure Ti6Al4V alloy. Moreover, the same sample was the most photocatalytically active and exhibited the potential for the sterilization of implants with the use of UV light and for other environmental applications.
Direct catalytic methanation of CO2 (from CO2/CH4 biogas mixture) to produce biomethane was conducted in a pilot demonstration plant. In the demonstration project (MeGa-StoRE), a biogas desulfurization process and thermochemical methanation of biogas using hydrogen produced by water electrolysis were carried out at a fully operational biogas plant in Denmark. The main objective of this part of the project was to design and develop a reactor system for catalytic conversion of CO2 in biogas to methane and feed biomethane directly to the existing natural gas grid. A process was developed in a portable container with a 10 Nm3/h of biogas conversion capacity. A test campaign was run at a biogas plant for more than 6 months, and long-time operation revealed a stable steady-state conversion of more than 90% CO2 conversion to methane. A detailed catalytic study was performed to investigate the high activity and stability of the applied catalyst.
The importance of advanced surface technology for the success of the ongoing energy turnaround in Germany has recently been discussed in this journal.1 The purpose of the present article is to add views based on the conditions valid for the Nordic region.