Artificial islands and land reclamation are one of the most important ways to expand urban space in coastal cities. Long-term consolidation of reclaimed material and compaction of marine sediments can cause ground subsidence, which may threaten the buildings and infrastructure on the reclaimed lands. Therefore, it is crucial to monitor the land subsidence and predict the future deformation trend to mitigate the damage and take measures for the land reclamation and any infrastructure. In this paper, a total of 125 SAR images acquired by the C-band Sentinel-1A satellite between June 2017 and September 2021 are collected. The small baseline subsets (SBAS) SAR interferometry (InSAR) method is first conducted to detect the land deformation in Xiamen and Zhangzhou cities of Fujian Province, China, and the distributed scatterers (DS)-InSAR method is used to recover the complete deformation history of some typical areas including Xiamen Airport in Dadeng Island and Shuangyu Island. Then, the sequential estimation and the geotechnical model are jointly applied to demonstrate the current and future evolution of land subsidence of the constructed roads on Shuangyu Island. The results show that the maximum cumulative deformation reaches 425 mm of Xiamen Xiang’an Airport and 626 mm of Shuangyu Island, and the maximum deformation is predicted to be as large as 1.1 m by 2026 of Shuangyu Island. This research will provide important guidelines for the design and construction of Xiamen Xiang’an Airport and Shuangyu Island to prevent and control land subsidence.

The extraction of underground minerals in hilly regions is highly susceptible to landslides, which requires the application of InSAR techniques to monitor the surface displacement. However, repeated mining for multiple coal seams can cause a large displacement beyond the detectable gradient of the traditional InSAR technique, making it difficult to explore the relationship between landslides and subsurface excavations in both temporal and spatial domains. In this study, the Tengqing landslide in Shuicheng, Guizhou, China, was chosen as the study area. Firstly, the large-gradient surface displacement in the line of sight was obtained by the fusion of SAR offset tracking and interferometric phase. Subsequently, a multi-segment logistic model was proposed to simulate the temporal effect induced by repeated mining activities. Next, a simplified probability integral method (SPIM) was utilized to invert the geometry of the mining tunnel and separate the displacement of the mining subsidence and landslide. Finally, the subsurface mining parameters and in situ investigation were carried out to assess the impact of mining and precipitation on the kinematic process of Tengqing landslides. Results showed that the repeated mining activities in Tengqing can not only cause land subsidence and rock avalanches at the top of the mountain, but also accelerate the landslide displacement. The technical approach presented in this study can provide new insights for monitoring and modeling the effects of repeated mining-induced landslides in mountainous areas.

Catastrophic landslides occur frequently in Guizhou Province, China, and the landslides in this area have special geomorphological, geological, and anthropogenic features. In order to detect and explore the distribution pattern and control factors of active landslides in Guizhou, firstly, a total of 693 active landslides throughout Guizhou Province were mapped based on the deformation rate, which was obtained by spatiotemporal filtering and Intermittent Small Baseline Subset (ISBAS) Interferometric Synthetic Aperture Radar (InSAR) techniques. Then, the relationships between the detected landslides and elevation, aspect, slope gradient, and stratigraphic lithology were analysed. Moreover, it was found that the landslides were mainly concentrated in three stratigraphic combinations, that is $T_{1}f~P_{2}l-d$, $T_{1}f~T_{1}yn$, and $T_{2}g~T_{1}yn$. Thereafter, the correlation coefficients between the landslide density and elevation and distance to the stratigraphic boundary were 0.54 and −0.19, indicating that the distribution of landslides was significantly controlled by the elevation and the boundary of specific stratigraphic combinations. Finally, we chose a typical landslide to explore how landslide development was controlled by the combined effects of elevation and stratigraphy by using ascending and descending InSAR results. We revealed that landslides occurred primarily in areas with a steep slope and a stratigraphy characterized by mudstone and sandstone.