This paper presents a sustainable recycling process for the separation and recovery of tempered glass from end-of-life photovoltaic (PV) modules. As glass accounts for 75% of the weight of a panel, its recovery is an important step in the recycling process. Current methods, such as mechanical, chemical and thermal processes, often lead to contamination of the glass and pose significant environmental risks. In response to these challenges, a thermal–mechanical delamination approach is proposed in this study. The method utilizes controlled heat application (hot air gun) to weaken the adhesive bond between the glass and encapsulant, allowing for separation with a thin stainless steel wire. Various analytical methods, including X-ray diffraction analysis (XRD), X-ray fluorescence (XRF) and scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDS), were used to verify the effectiveness of the proposed method. The results show that the proposed method is effective. In less than a minute, the glass layer was separated and recovered with a success rate of over 99%, with no degradation of the material or release of gasses. The significance of this process lies in its ability to recover high-purity glass while minimizing the impact on the environment. This opens up the possibility of reusing the recovered tempered glass in new PV panels or other applications, reducing the need for virgin materials and lowering the overall environmental footprint of the solar energy industry.
This paper presents the jig operating properties of the selected final parameters of the hard coal concentrate. The quality parameters of the product, such as the yield and ash content, were evaluated in terms of the technical and hydrodynamic parameters of the jig’s operation. The research program included a series of experiments in which the efficiency and the amount of hutch water were changed. The variables selected and analyzed were divided into two categories, i.e., one related to the characteristics of the concentrate produced, and the other to the characteristics of the jig operation. Models were built for narrowed particle size fractions based on concentrate yield and ash content in the concentrate. In addition, a multidimensional analysis was performed, considering variables such as machine throughput, which was determined by the flow rate of the material, the amount of hutch water, the quality of the concentrate, and the amount of concentrate, as well as the accuracy of the jig operation expressed by the imperfection. Two main parameters were taken into account for modeling the operation to examine their significance of influence on the final responses in terms of the possibility of adjusting the value of independent settings of the jig operation. The presented approach to modeling the operation of the jig can be extended by considering the impact of other parameters, taking into account the variability of the final effect, as long as it is allowed under the industrial conditions of machine operation and the assumed production requirements. The approach presented in this paper is a new technique, which was not found in the literature.
29 August 2025 in Solar Energy Materials and Solar Cells