Giannino Ponchio Camillo

Mr. Giannino Ponchio Camillo

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 June 2020 in Experiments in Fluids
Verified
Journal Article
Open access
PDF file
GCGiannino Ponchio Camillo
Giannino Ponchio Camillo
Alexander WagnerAlexander Wagner
Alexander Wagner
CDChristian Dittert
Christian Dittert
LBLeroy Benjamin
Leroy Benjamin
VWViola Wartemann
Viola Wartemann
RHRüdiger Hink
Rüdiger Hink
The influence of localized nitrogen transpiration on second mode instabilities in a hypersonic boundary layer is experimentally investigated. The study is conducted using a $$7^\circ$$ 7 ∘ half-angle cone with a length of 1100 mm and small nose bluntness at $$0^\circ$$ 0 ∘ angle-of-attack. Transpiration is realized through a porous Carbon/Carbon patch of $$44 \times 82$$ 44 × 82 mm located near the expected boundary layer transition onset location. Transpiration mass flow rates in the range of 0.05–1% of the equivalent boundary layer edge mass flow rate were used. Experiments were conducted in the High Enthalpy Shock Tunnel Göttingen (HEG) at total enthalpies around 3 MJ/kg and unit Reynolds numbers in the range of $$1.4 \cdot 10^6 \,$$ 1.4 · 10 6 to $$6.4 \cdot 10^6 \, {\text {m}}^{-1}$$ 6.4 · 10 6 m - 1 . Measurements were conducted by means of coaxial thermocouples, Atomic Layer Thermopiles (ALTP), pressure transducers and high-speed schlieren. The present study shows that the most amplified second mode frequencies were shifted to lower values as nitrogen is transpired into the boundary layer. In some cases the instability amplitudes were found to be significantly reduced. The observed frequency reduction was verified to correlate with the change of the relative sonic line height in the boundary layer. The amplitude damping was observed to occur only until the most amplified frequencies were reduced to around 50% of their undisturbed values. When transpiration within this limit was performed shortly upstream of the natural boundary layer transition onset, a transition delay of approximately 17% could be observed. Graphic

20 June 2023 in Aerospace
Verified
Journal Article
Open access
PDF file
GCGiannino Ponchio Camillo
Giannino Ponchio Camillo
Alexander WagnerAlexander Wagner
Alexander Wagner
TTTakahiko Toki
Takahiko Toki
CSCarlo Scalo
Carlo Scalo
This work investigates a hypersonic turbulent boundary layer over a 7° half angle cone at a wall-to-total temperature ratio of 0.1, M∞=7.4 and Re∞m=4.2×106 m−1, in terms of density fluctuations and the convection velocity of density disturbances. Experimental shock tunnel data are collected using a multi-foci Focused Laser Differential Interferometer (FLDI) to probe the boundary layer at several heights. In addition, a high-fidelity, time-resolved Large-Eddy Simulation (LES) of the conical flowfield under the experimentally observed free stream conditions is conducted. The experimentally measured convection velocity of density disturbances is found to follow literature data of pressure disturbances. The spectral distributions evidence the presence of regions with well-defined power laws that are present in pressure spectra. A framework to combine numerical and experimental observations without requiring complex FLDI post-processing strategies is explored using a computational FLDI (cFLDI) on the numerical solution for direct comparisons. Frequency bounds of 160 kHz <f<1 MHz are evaluated in consideration of the constraining conditions of both experimental and numerical data. Within these limits, the direct comparisons yield good agreement. Furthermore, it is verified that in the present case, the cFLDI algorithm may be replaced with a simple line integral on the numerical solution.

1 February 2025 in Physics of Fluids
Verified
Journal Article
Open access
ACA. Cerminara
A. Cerminara
RNR. Nayak
R. Nayak
JPJonathan Potts
Jonathan Potts
HTH. Tanno
H. Tanno
MKMarkus J. Kloker
Markus J. Kloker
Alexander WagnerAlexander Wagner
Alexander Wagner
This work presents recent advancements in the study of film cooling in hypersonic flows, considering experimental and numerical investigations, with the aim to characterize the wall-cooling performance in different coolant injection and baseflow conditions in a Mach number range 2–7.7. The study explores the mutual interaction between the injected coolant film and the boundary-layer flow, with emphasis on the effects of wall blowing on the boundary-layer characteristics, stability, and transition to turbulence, as well as the effect of transition on wall-cooling performance. Considered flow configurations include cases of effusion cooling in both wall-normal or slightly inclined and wall-parallel blowing, different types of coolant, cases of favorable pressure gradient compared to zero pressure gradient, as well as transpiration cooling cases at different blowing ratios and surface geometries. For the transpiration cooling case, experiments in different hypersonic wind tunnel facilities are presented for flat plate and cone geometries, with coolant injected through C/C porous samples, whereas numerical simulations of modeled porous injection are presented for a flat plate and a blunt cone, showing results for the boundary-layer receptivity with coolant injection and the associated effects on transition and cooling performance. A summary of the main findings is provided along with a critical analysis based on a comparative study to evaluate the effect of each configuration, injection strategy, and key parameters on the boundary-layer flow and the feedback on wall-cooling performance. Conclusions are drawn about potential directions of study for the further development and optimization of the film cooling technique for future hypersonic vehicles.

1 April 2023 in Review of Scientific Instruments
Verified
Journal Article
Open access
PDF file
GCGiannino Ponchio Camillo
Giannino Ponchio Camillo
Alexander WagnerAlexander Wagner
Alexander Wagner
An analytic methodology is presented to reconstruct the pressure waveform of flowfields with circular symmetry from the phase shift detected with Focused Laser Differential Interferometry (FLDI). A weak blast wave generated by an electric spark in ambient air is investigated with the proposed approach. Values of separation distance between the differentiating foci of the FLDI Δx of 76, 120, 175, and 252 μm are employed to probe the flowfield at locations between 3 and 50 mm from the spark source. In a subset of these distances, reference measurements of peak pressure obtained with a surface pressure sensor indicate good agreement with the reconstructed data when small separation distances are used. Further analysis of FLDI reconstructed data is conducted using theoretical correlations for N-waves in terms of the distribution of pressure peak amplitude and compression phase as the wave front propagates. Agreement with theory is verified for all differentiation separation distances except the largest, for which peak pressure comparison shows a 10% loss of measured vs predicted value. A computational FLDI is employed to scrutinize the simplifying hypotheses supporting the waveform reconstruction approach. The direct comparison between experimental and computational FLDI output reveals additional discrepancies for intermediate Δx values but very good agreement for the smallest Δx. The proposed methodology is thus verified to be reasonable, upon appropriate minimization of the FLDI differentiation distance. A parametric analysis using computational FLDI indicates the adequate value of FLDI Δx to be 20% or less of the flowfield characteristic length in terms of density gradient.

1 November 2024 in Physics of Fluids
Verified
Journal Article
Open access
PDF file
EBE. K. Benitez
E. K. Benitez
MAMatthew Aultman
Matthew Aultman
LDLian Duan
Lian Duan
GCGiannino Ponchio Camillo
Giannino Ponchio Camillo
JJJoseph Jewell
Joseph Jewell
While designed to suppress disturbances located away from its beam foci, focused laser differential interferometry (FLDI) is known to have some integration of signals along its optical axis. This is especially true for longer-wavelength signals, although smaller-scale flow structures also have a non-infinitesimal sensitivity length. This study investigates the performance of FLDI in a hypersonic turbulent boundary layer to better understand its behavior. FLDI simulations were conducted using both full-scale direct numerical simulation (DNS) and spatially averaged DNS inputs to directly assess the influence of smaller flow structures on FLDI measurements. The full-scale FLDI results indicate that integration along the optical axis likely results in lower FLDI amplitudes than for true point measurements. Comparison with the spatially averaged FLDI simulations reveals the significance of small-scale structures in FLDI signal roll-off and root mean square amplitudes. Further, the influence of FLDI setup parameters on the response across the frequency spectrum are analyzed. Circular, Gaussian beams with smaller widths are verified to present increased performance relative to elliptical or uniform-intensity beams. Also, measurements using distinct differentiation directions suggest an experimental way to measure turbulence isotropy scales. These results have notable implications for understanding hypersonic turbulent boundary-layer dynamics and interpreting experimental data. Distribution Statement A: Approved for Public Release; Distribution is Unlimited. PA# AFRL-2024-4678; Cleared 08/23/2024.

20 January 2025 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
TTTakahiko Toki
Takahiko Toki
VSVictor C.B. Sousa
Victor C.B. Sousa
YCYongkai Chen
Yongkai Chen
GCGiannino Ponchio Camillo
Giannino Ponchio Camillo
Alexander WagnerAlexander Wagner
Alexander Wagner
CSCarlo Scalo
Carlo Scalo
Large-eddy simulations (LES) of a hypersonic boundary layer on a $7^\circ$ -half-angle cone are performed to investigate the effects of highly cooled walls (wall-to-recovery temperature ratio of $T_w / T_r \sim 0.1$ ) on fully developed turbulence and to validate a newly developed rescaling method based on volumetric flow extraction. Two Reynolds numbers are considered, $Re_m = 4.1 \times 10^6\ \text {m}^{-1}$ and $6.4 \times 10^6\ \text {m}^{-1}$ , at free-stream Mach numbers of $M_\infty = 7.4$ . A comparison with a reference laminar-to-turbulent simulation, capturing the full history of the transitional flow dynamics, reveals that the volumetric rescaling method can generate a synthetic turbulent inflow that preserves the structure of the fluctuations. Equilibrium conditions are recovered after approximately 40 inlet boundary layer thicknesses. Numerical trials show that a longer streamwise extent of the rescaling box increases numerical stability. Analyses of turbulent statistics and flow visualizations reveal strong pressure oscillations, up to $50\,\%$ of local mean pressure near the wall, and two-dimensional longitudinal wave structures resembling second-mode waves, with wavelengths up to 50 % of the boundary layer thickness, and convective Mach numbers of $M_c \simeq 4.5$ . It is shown that their quasi-periodic recurrence in the flow is not an artefact of the rescaling method. Strong and localized temperature fluctuations and spikes in the wall-heat flux are associated with such waves. Very high values of temperature variance near the wall result in oscillations of the wall-heat flux exceeding its average. Instances of near-wall temperature falling below the imposed wall temperature of $T_w=300$ K result in pockets of instantaneous heat flux oriented against the statistical mean direction.