This paper describes the use of coal-oil agglomerates in flotation to increase the gold recovery from an ore containing fine gold particles. The effects of operating parameters on gold flotation recovery such as oil type, particle size of agglomerating material, agglomerate/ore and oil/ore ratios were investigated. The studies showed that petroleum oils are more effective than vegetable oils in oil agglomeration of Kozlu coal and coal-oil assisted gold flotation. Gold recovery can be increased using a higher amount of agglomerates in the process; however, gold grade of the flotation concentrates is reduced significantly. The use of bridging oil at high concentrations in the agglomeration process provides high-grade gold concentrates, but lower recoveries. The utilization of coarser coal particles in the coal-oil agglomeration stage leads to higher selectivity and recovery values for gold particles.
1 January 2013 in International Journal of Coal Geology
In this study, comminution of coal with waterjets was performed to determine the factors that influence the particle size reduction. To carry out these experiments, a bituminous coal sample with an ash value of 31% was exposed to waterjet action within a conventional abrasive cutting head coupled with a specially designed cavitation chamber. Original coal feed of 371 µm volume mean diameter and its subsamples of 59, 172, 323, and 527 µm were used to investigate the effect of pressure on particle size reduction. For the purpose of this study, the comminution system was operated at 69, 138, 207, and 276 MPa. Physical properties such as particle size distribution and volume mean diameter were used for evaluation of the efficiency of comminution. Initial feed size was found as a dominant factor affecting the degree of size reduction. The increase in the cavitation system operating pressure resulted in finer products. Scanning electron microscopy studies of particle shape and morphology indicated transition from flaky to round and blocky particle shapes as a result of pressure increase. Severe clay dispersion was associated with all test conditions.
The effects of different physical parameters such as pulp density, aeration conditions, and impeller speed on the performance of coal-oil assisted gold flotation were investigated in this study. The experiments were conducted using samples taken from an epithermal gold ore deposit. The results demonstrated that increasing the solid concentration in feed pulp slightly improves recovery of gold particles, but accompanied by significant decreases in concentrate grade. At low aeration conditions gold recovery was relatively low whereas at high aeration conditions the selectivity was poor. The use of higher level of agitation in the agglomerate re-formation stage brought about an increase in gold recovery; however, gold grade of the concentrates tended to decline. Gold grade of the concentrate was significantly increased by reloading of the coal oil agglomerates; on the other hand, substantial decreases were observed in total gold recovery after each successive cycle.
Numerous research studies have been done to improve the gold recovery methods and to fi nd alternative processing techniques in the last decade. The main goal in this search has become to design an effi cient plant employing environmentally acceptable processes today. For this purpose, the application of environmentally friendly, no chemical included techniques like centrifugal gravity separators are preferably used in gold recovery plants prior to or in place of cyanidation. In this study, the recovery of the gold particles accumulated in the grinding circuit of a CIP plant was investigated by using Knelson centrifugal separator. A KC-MD7.5 Knelson concentrator was installed in the grinding circuit of Bergama/Ovacik CIP plant. The concentrator was operated while the Mastra gold ore cyanidation tests were running on the plant.