The objective of this study was to investigate the effect of a premixed ethanol ratio based on the same total heating value in a cylinder on the equivalence ratio distributions and the injected fuel droplet behavior in the cylinder of an RCCI engine. The spray simulation was conducted in two parts. First, we carried out spray validation simulations to determine the spray-influenced factor of the test injector. Next, engine simulations were performed with the spray-influenced factor obtained from the spray validation simulations to investigate the effect of the premixed ethanol ratio based on the same total heating value in a cylinder on the injected fuel atomization and the equivalence ratio distributions. The introduced total heating value was fixed at 595 J based on the lower heating value of diesel, 14 mg. The heating value of the premixed ethanol ratio varied from 0% to 40% based on the same total heating value in the cylinder in steps of 10%. It was revealed that when the premixed ethanol ratio based on the same total heating value in the cylinder was increased, the spray tip penetration value was reduced after 4 deg of diesel was injected because of the short injection duration and the small amount of diesel fuel used. The SMD value was also increased up to 32.58% with an increasing premixed ethanol ratio because of the low kinetic energy of the injected fuel, the short injection duration, the slow evaporation of the injected fuel and the low cylinder temperature.

The objective of this study is to investigate the effect of water injection into intake port on the performance of small CI engine. The ECFM-3Z model was applied for the combustion analysis model, and the amount of injected water were varied 10%, 20% and 30% of injected fuel mass. The results of this work were compared in terms of cylinder pressure, rate of heat release (ROHR), and the ISNO and soot emissions. It was found that the cylinder pressure was decreased from 1.2% to 9.2% when the amount of injected water was increased from 10% to 30%. In the results, NO emission significantly decreased from about 24% to about 85% when the amount of injected water increased due to the specific heat and latent heat of water. Considering the test results, the best conditions for the simultaneous reduction of NO and soot is the BTDC 05deg of injection timing and 30% of water injection mass. It can be expected the best IMEP and ISFC characteristics.

The objective of this study is to numerically investigate the effect of cryogenic intake air temperature on the in-cylinder temperature and formation of exhaust emissions in a CI engine. The experimental setup was consisted of a single-cylinder diesel engine. The intake air temperature was varied from 18 °C to 40 °C, which was controlled by cooler and heater. Submodels were applied for the simulations of physical/chemical phenomenon of spray and combustion behaviors. The intake air temperature in numerical condition was varied from −18 °C to 18 °C. The numerical results were validated with experimental results for the reliability of this work. The results of this work were compared in terms of cylinder pressure, rate of heat release (ROHR), indicated specific nitrogen oxide (ISNO), indicated specific carbon monoxide (ISCO), ignition delay, in-cylinder temperature distributions, equivalence ratio distributions, NO mass fraction, and CO mass fraction. When the intake air temperature was decreased in steps of 9 °C, the cylinder temperature and cylinder pressure were decreased in steps of about 14.5 °C and 0.05 MPa, respectively. In all cases, the area where the NO formed in the cylinder was identified with the area of the high equivalence ratio and temperature in the cylinder. The amount of CO generation shows the similar distributions in the cylinder according to the intake air temperature conditions. However, the oxidation rate of formed CO under the low intake air temperature was lower than those of the high intake air temperature.