A controlled and environmentally benign route for silver nanoparticle (AgNP) formation is achieved using an ethanolic–water (80 : 20) extract of male Carica papaya L. flowers as a combined reductant–stabilizer system.
12 September 2023 in Materials Today Communications
Green synthesis and nanomaterials have been the current trends in biomedical materials. In this study, Piper chaudocanum L. leaf extract-doped ZnO nanoparticles (PLE-doped ZnO NPs), a novel nanomaterial, were studied including the synthesis process, and the biomedical activity was evaluated. PLE-doped ZnO NPs were synthesized by the co-precipitation method, with differences in the synthesis procedures and dosages of the extract. The X-ray diffraction, Fourier transform infrared, scanning electron microscopy, energy dispersive X-ray spectroscopy, Brunauer–Emmett–Teller, ultraviolet-visible diffuse reflectance spectroscopy, and photoluminescence spectrum analysis results showed that the biosynthesized PLE-doped ZnO NPs were pure and in a hexagonal wurtzite phase. The PLE-doped NPs were synthesized by adding the extract to the zinc acetate solution before adjusting the pH and exhibited the smallest size (ZPS50 was 22 nm), the richest in the surface organic functional groups and the best optical activity. The highest antibacterial activity against P. aeruginosa and S. aureus was observed at 100 µg/mL of ZPS50 NPs, and the inhibition zone reached 42 and 39 nm, respectively. Moreover, ZPS50 NPs showed a moderate effectiveness against KB cancer cells with an IC50 value of 43.53 ± 2.98 µg/mL. This present study’s results suggested that ZPS50 NPs could be a promising nanomaterial in developing drugs for treating human epithelial carcinoma cells and infectious illnesses.
Pyrochar (BP7003) simultaneously removes Cu 2+ and DR79 via distinct yet interacting mechanisms, with synergy at concentrations and competition at higher loadings.
18 October 2023 in TNU Journal of Science and Technology
Nghiên cứu này trình bày kết quả nghiên cứu chế tạo than sinh học từ bã chưng cất tinh dầu sả theo phương pháp thủy nhiệt, sau đó được hoạt hóa bằng KOH 5M ở nhiệt độ phòng trong 24 h, nghiên cứu các đặc trưng vật liệu và khả năng hấp phụ amoxicillin (AMO) trong môi trường nước. Các đặc trưng vật liệu được xác định bằng các phương pháp nhiễu xạ tia X (XRD), phương pháp phổ hồng ngoại (IR), kính hiển vi điện tử quét (SEM) và phương pháp phân tích bề mặt riêng (BET). Kết quả cho thấy, nguyên liệu đã bị carbon hóa tốt, giàu các nhóm chức hữu cơ, diện tích bề mặt riêng đạt 24,6 m2/g. Các yếu tố ảnh hưởng tới khả năng hấp phụ AMO trong môi trường nước của than sinh học sả đã được khảo sát như pH, nồng độ đầu của AMO, hàm lượng than sử dụng, thời gian hấp phụ. Kết quả cho thấy, sự hấp phụ tốt nhất xảy ra tại pH bằng 5, đạt cân bằng hấp phụ sau 3 h, khi nồng độ đầu của AMO càng nhỏ (5 -10 ppm) và lượng than sử dụng đủ lớn (3,0 – 5,0 g/L) thì hiệu suất hấp phụ đạt khoảng 90%. Quá trình thực nghiệm hấp phụ phù hợp với mô hình lý thuyết hấp phụ đẳng nhiệt Freundlich và mô hình động học bậc hai, cho thấy cơ chế hấp phụ có tính trung gian giữa hấp phụ vật lý và hấp phụ hóa học.