Biochar was prepared by the hydrothermal carbonization (HTC) of palm leaves, characterized, and utilized as an adsorbent for Malachite Green dye (MG). The Higher Heating Value (HHV) of biochar depends on the carbonization temperature and has a maximum value of 24.81 MJ/kg. Activation using H2O2 oxidation of HTC biochar prepared at 208 °C produced AHTC with improved capacity. The optimum pH was found to be in the range 7–8. Freundlich, Langmuir, Temkin, and Dubinin–Radushkevich adsorption isotherms were used to study MG adsorption data. The Langmuir isotherm provided the best fit for experimental data. Experiments conducted using activated biochar AHTC at 25 °C resulted in an adsorption capacity of 62.80 mg/g, far greater than what was observed for HTC biochar (45.59 mg/g). The maximum adsorption capacity was 88% when the concentration of MG solution was 66 ppm. The free energy change in adsorption DG° indicated that the adsorption process was spontaneous. Adsorption followed pseudo-second-order kinetics. Fixed-column adsorptions models, namely, Thomas, Yan et al. and Yoon–Nelson models, were investigated for AHTC. The column adsorption capacity determined by the Thomas model was 33.57 mg/g. In addition, a computational investigation has been carried out to determine the structural and electronic features, as well as the quantum chemical parameters of HTC and MG. Moreover, the interaction between the HTC and MG is investigated, which is further elaborated by performing non-covalent interaction (NCI) through the reduced density gradient (RDG) analysis. Thus, the easily prepared hydrochar from abundant waste palm leaves can be used as a high-value biocoal and efficient adsorbent of the cationic dye malachite green.
18 December 2019 in Chemical Engineering Communications
A carbon-rich hydrochar HTC-PL was prepared by hydrothermal carbonization of Phoenix dactylifera palm leaves. HTC-PL was chemically modified with H2O2 to give activated AHTC-PL. High-resolution transmission electron microscope HRTEM of AHTC-PL indicated sponge-like cubic mesoporous nanostructures. Thermal analysis of HTC-PL and AHTC-PL shows two degradation steps around 330 and 400 °C. The physico-chemical properties and energy generation capability of hydrochar HTC-PL were evaluated. The hydrochar has higher heating value of 20.95 MJ/kg. Langmuir isotherm and pseudo-second-order kinetic provided the best fit to the adsorption data of lead by HTC-PL materials. Removal of lead by AHTC-PL at 25 °C resulted in an adsorption capacity of 74.5 mg/g while that of HTC-PL biochar is 17.8 mg/g. The adsorption data using a fixed-column technique were best fitted by Thomas model. The % removal efficiency of Pb2+ ions by AHTC-PL column was almost unchanged for three cycles.
The exposure to exhaust emissions from fuels as diesel and pyrolysis oil may result in adverse effects on human lungs. This study investigated the effects of exposing mice to the exhaust emissions from diesel, biodiesel or pyrolysis oil, for 1 hour/day for 3 days, on lung oxidative stress and whether selenium administration into these mice affects the oxidative stress. The levels of lung malondialdehyde and nitric oxide were increased after exposure to pyrolysis oil exhaust. The intraperitoneal injection of 1.78 μg selenium/kg body weight 15 minutes before the exposure to the pyrolysis oil exhaust (pyrolysis oil + selenium group) restored the normal levels of malondialdehyde and nitric oxide. The catalase and SOD activities were decreased in the groups of the mice exposed to the exhaust emissions from pyrolysis oil, biodiesel or diesel. Selenium pre-treatment of these groups showed no significant change in the activities of both enzymes. In conclusion, the increased lung levels of malondialdehyde and nitric oxide after the exposure to the exhaust emission from pyrolysis oil were restored to normal by selenium administration.
14 July 2018 in Journal of Taibah University for Science
Pyrolysis oil produced from municipal solid waste is being used as a fuel and little is known about the toxicity of its vapours. We investigated the effects of exposing mice to pyrolysis oil vapours on oxidative stress in lungs. This study also examined whether selenium administration exerts protective actions against the effects of pyrolysis oil vapours. Our results showed that the exposure of mice to these vapours increased the levels of malondialdehyde (MDA) and nitric oxide (NO) and decreased catalase activity in the lung as compared to that in control mice. Selenium administration before the exposure to pyrolysis oil vapours restored the levels of MDA and NO as well as catalase activity in lungs to normal. Therefore, the exposure of mice to pyrolysis oil vapours increased the oxidative stress in the lung and the administration of selenium could alleviate the effects of this exposure on oxidative stress.