The enzymatic starch hydrolysis and bioethanol production from a variety of sweet potato developed for bioenergy purposes (K 9807.1) on the basis of its high starch yields, was studied. Drying at 55°C and 95°C of sweet potato neither affected the sugar content nor the starch enzymatic hydrolysis efficiency. Simultaneous saccharification and ethanol fermentations for dry matter ratio of sweet potato to water from 1:8 to 1:2 (w/v) were studied. Fresh sweet potato and dried at 55°C (flour) were assayed. At ratios of 1:8, similar results for fresh sweet potato and flour in terms of ethanol concentration (38–45 g/L), fermentation time (16 h) and sugar conversion (~ 100%) were found. At higher dry matter content, faster full conversion were observed using flour. A higher ratio than that for fresh sweet potato (1:2.2) did not improve the final ethanol concentration (100 g/L) and yields. High ethanol yields were found for VHG (very high gravity) conditions. The sweet potato used is an attractive raw matter for fuel ethanol, since up to 4800 L ethanol per hectare can be obtained.

In this work, Eucalyptus grandis sawdust was subjected to steam explosion as the first step in cellulosic ethanol production within a biorefinery approach. The effect of the moisture content in the eucalypt sawdust (8 and 50%) and pretreatment process variables, such as temperature and residence time, were evaluated along with the influence of the water washing of steam-exploded solids on enzymatic hydrolysis and C6 fermentation yields. All other process streams were characterized to evaluate the recovery yield of valuable co-products. A recovery of nearly 100% glucans in the solid fraction and 60% xylans in the liquid fraction, mainly as partially acetylated oligomers, was obtained. The best enzymatic hydrolysis efficiencies (66–67%) were achieved after pretreatment at 205 °C for 10 min. The washing of pretreated sawdust with water improved the hydrolysis efficiencies and ethanol production yields by 10% compared to the unwashed pretreated solids under the same experimental condition. The highest ethanol yields were achieved after pretreatment of the sawdust with an 8% moisture content at 205 °C for 10 min, enzymatic hydrolysis at 13 wt% total solids with 25 FPU/g glucans, and fermentation with S. cerevisiae PE-2. In this case, 227 L ethanol and 40 kg total xylose (including xylo-oligomers) were obtained per ton of dry eucalypt sawdust.

The generation of eucalypt sawdust has increased in Uruguay with the expansion of pulp and paper industrial sites. Currently, most of this readily available feedstock is either not used or applied for producing heat and power by combustion in biomass boilers. In this work, eucalypt sawdust was subjected to steam explosion as the first step for cellulosic ethanol production within the biorefinery concept. The effect of sawdust moisture content, pretreatment temperature and residence time were evaluated, along with the influence of water washing of steam-exploded solids on enzymatic hydrolysis and fermentation yields. After steam explosion, 60% xylans and 97% acetyl groups were recovered mainly as oligomers and acetic acid in the pretreatment liquor. Eucalypt sawdust moisture content affected the enzymatic hydrolysis performance and glucan conversion efficiency. Water washing after pretreatment improved hydrolysis efficiencies and ethanol production yields by 10% with respect to the unwashed pretreated solids at the same experimental condition. The best ethanol yields were obtained using PSSF (pre-saccharification and simultaneous saccharification and fermentation) after pretreatment at 205°C for 10 min, using sawdust with an 8% moisture content. In this case, 227 L ethanol and 40 kg total xylose (including xylo-oligomers) were obtained per ton of dry eucalypt sawdust.