Summary: Investigation of the detailed pyrolysis characteristics of tobacco raw materials is important for the understanding of product design and consumption. In this work, pyrolysis characteristics and kinetic models of cigar filler tobacco (CFT), cigar wrapper tobacco (CWT), and flue-cured tobacco (FCT) were investigated by using a thermogravimetric analyzer coupled with Fourier-transform infrared spectroscopy (TG-FTIR). The pyrolysis of different tobacco samples could be divided into four stages based on the derivative thermogravimetric analysis (DTG) curves. Flue-cured tobacco underwent a marked decomposition process at lower temperatures (about 200 °C), while the thermal decomposition of cigar tobacco occurs at higher temperatures. During the pyrolysis process, evolved gases including H 2 O, CO 2 , CH 4 , CO, carbonyls, alcohols, phenols and aromatic compounds were detected by FTIR. CWT released more CO 2 than CFT, while the amount of CO 2 , CH 4 , CO and aromatic compounds released by flue-cured tobacco was lower than that of cigar tobacco. The pyrolysis kinetics of tobacco leaves were further analyzed and compared through the isoconversional FWO (Flynn-Wall-Ozawa) and KAS (Kissinger-Akahira-Sunose) methods. The activation energy of FCT (from 100.1 kJ mol −1 to 192.1 kJ mol −1 ) was lower than that of CFT (from 207.36 kJ mol −1 to 319.28 kJ mol −1 ) and CWT (from 160.40 kJ mol −1 to 260.45 kJ mol −1 ). The thermal decomposition kinetics of different tobaccos were analyzed by M álek and C oats -R edfern methods.
1 December 2023 in Contributions to Tobacco & Nicotine Research
SUMMARY: Heated tobacco products (HTPs) are a recent category of tobacco products, with their relative safety compared to cigarette smoking and potential to help smokers to quit being two reasons why regulators may consider their market approval. Designed to heat tobacco rather than to burn in order to produce aerosol, different heating techniques are applied to commercial HTPs, which may result in differing aerosol formation. Therefore, each product requires separate assessment. This work focuses on a closed-end HTP (coded as HTP-A), which is electrically heated and designed to allow puffing air flow to bypass its tobacco section, resulting in reduced oxygen concentration within the tobacco section during heating and aerosol forming. To provide a preliminary aerosol chemistry and in vitro toxicological screening, this study assessed HTP-A against a commercial electrically heated HTP (IQOS TM , coded as HTP-B) and a 3R4F reference cigarette. Under Health Canada Intense (HCI) smoking regime, the levels of 9 regulatory priority toxicants in the aerosol of HTP-A were either reduced or comparable to those in HTP-B on a per-stick basis. Additionally, both HTPs showed significant reduction (greater than 90%) in comparison to those measured in mainstream smoke of 3R4F cigarette for these toxicants. Using a set of standard in vitro toxicological assays (Ames, Micronucleus and Neutral Red Uptake), the two HTPs showed no observable responses while significant toxicity responses were recorded for 3R4F’s total particulate matter. Based on these preliminary results, the novel closed-end HTP-A design may provide similar toxicological profiles to the comparator HTP-B. Further toxicological and clinical assessments are warranted to evaluate HTP-A’s potential for exposure or disease risk reduction. [Contrib. Tob. Nicotine Res. 32 (2023) 146–156]
In this present study, silver nanoparticles (AgNPs) immobilized hydrochar was prepared through a facile one-pot co-hydrothermal carbonization of tobacco stem and silver nitrate. The effect of concentration of silver precursor, hydrothermal temperature and reaction time on the chemical compositions, structural property, combustion performance, as well as gaseous products release behavior of the resultant AgNPs immobilized hydrochar were evaluated. The co-hydrothermal treatment decreased the volatile matter while increased the ash content of hydrochar. Single-phase AgNPs were successfully generated and evenly immobilized onto the hydrochar during the hydrothermal process. The immobilized AgNPs played a notable catalytic role during the char combustion stage, thereby decreased the ignition temperature, burnout temperature and maximum rate temperature for char combustion. Meanwhile, TG-FTIR analysis suggested that the emission amount of harmful gas CO during hydrochar combustion was reduced due to the catalytic effect of AgNPs. This phenomenon may indicate the appropriate amount of nanoparticles immobilization could enhance the combustion behavior of hydrochar fuel.
1 November 2022 in Contributions to Tobacco & Nicotine Research
Summary: A novel concept is described here that utilizes externally applied heat to a solid rod of reconstituted tobacco biomass to form a stream of aerosol under progressively oxygen-deficient atmosphere. The boundary of auto-ignition was determined at oxygen concentrations of 0%, 5%, 10%, and 21% and then the effects of these different atmospheres on various parameters were studied. Experimental results indicated that the ignition temperature decreased with the increase of oxygen concentration and a negative temperature coefficient (NTC) for atmosphere with oxygen was observed at before but close to ignition temperature. Significant differences in the yields of CO and CO 2 between oxygen and oxygen-free atmosphere were observed. The mass of aerosol produced under an inert atmosphere and reduced-oxygen atmosphere were characterized with selected volatile and semi-volatile components, phenols, aldehydes, and other organic compounds of interests. In addition, higher oxygen concentration resulted in higher bulk and surface oxygen content of solid-phase residue, the reduction of carbon and hydrogen element content and related functional groups, and the content of inorganic compounds also exhibited an increase with oxygen concentration. By systematically changing oxygen concentrations of the biomass bed with increasing temperatures, an aerosol stream of controlled chemical composition and yields could be formed without leading to ignition. Key chemical markers of inhalation harm were measured and compared to each other under different degrees close to combustion. Studying reconstituted tobacco or other biomass materials in such a way could provide alternative and useful information in the design heated biomass aerosol generators.
1 April 2017 in Beiträge zur Tabakforschung International/Contributions to Tobacco Research
Summary: Establishing a realistic gas flow velocity distribution inside a cigarette filter during smoking is important to understand filtration mechanisms of different mainstream smoke species and the overall effect of filter designs on mainstream smoke composition. In this paper, an experimental method is described which directly measures the gas pressure field inside a cellulose acetate filter during cigarette smoking. This was demonstrated by using 3R4F research reference cigarettes smoked under a 35 mL puff of 6 s duration. In addition, filter temperature measurements were also carried out at multiple locations within the filter. Both the temperature and pressure sensing locations were selected to match the radial and longitudinal directions of the cigarette filter. The temperature and pressure measurements were then used to calculate the velocity according to Darcy’s Law along the mainstream flow direction in the cigarette filter at each puff. The spatially resolved maps of temperature, pressure and flow velocity on a puff-by-puff basis provide useful insights into the dynamic filtration of smoke aerosol under the influence of the approaching burning coal and progressive accumulation of smoke particulate matter.