Tropospheric delay (TD) parameter estimation is a critical issue underlying high-precision data processing for global navigation satellite systems (GNSSs). The most widely used TD parameter estimation methods are the random walk (RW) and piece-wise constant (PWC). The RW method can effectively track rapid variations of tropospheric delay, but it may introduce excessive noise. In contrast, the PWC method introduces less noise, but it is less adaptable to cases of large variations of tropospheric delay. To address the problem of how to choose the optimal TD parameter estimation method, this paper investigates the variation patterns of international GNSS service zenith tropospheric delay (IGS ZTD) products and proposes a combined strategy model for TD parameter estimation. Firstly, this paper avoids the day-boundary jumps problem of IGS ZTD products by grouping based on single-day data. Secondly, this paper introduces discrete point areas (DPAs) to measure the magnitude of the ZTD values and uses comprehensive indicators to reflect the variation of ZTD. Next, based on the Köppen-Geiger climate classification, this study selected five different climate classifications with a total of 20 IGS stations as experimental data. The data assessed span from day of year (DOY) 001 to DOY 365 in 2022. This paper then applied 26 different parameter estimation strategies for static precise point positioning (PPP) data processing, and the parameter estimation strategies that were used include the RW and PWC (with the piece-wise constant ranging from twenty minutes to five hundred minutes at twenty-minute intervals). Finally, ZTD and positioning results were obtained using various parameter estimation methods, and a combined strategy model was established. We selected five different climate classifications of IGS stations as validation data and designed three sets of comparative experiments: RW, PWC120, and the combined strategy model, to verify the effectiveness of the combined strategy model. The experimental results revealed that: RW and the combined strategy model have a comparable ZTD accuracy and both are superior to PWC120. The combined strategy model improves the positioning accuracy in the U direction compared to RW and PWC120. In arid (B) and polar (E) regions with a small variation of TD, the PWC120 strategy displayed a better positioning accuracy than the RW strategy; in equatorial (A) and warm-temperate (C) regions, where there are large variations of TD, the RW strategy exhibited a better positioning accuracy than the PWC120 strategy. The combined strategy model can flexibly select the optimal parameter estimation method according to the comprehensive indicator while ensuring ZTD estimation accuracy; it enhances positioning accuracy.

The BeiDou Navigation Satellite System (BDS) has developed rapidly, and the combination of BDS Phase II (BDS-2) and BDS Phase III (BDS-3) has attracted wide attention. It is found that there are code ISBs between BDS-2 and BDS-3, which may have a certain impact on the BDS-2 and BDS-3 combined positioning. This paper focuses on the performance of BDS-2/BDS-3 combined B1I single-frequency pseudorange positioning and investigates the positioning performance with and without code ISBs correction for different types of receivers, include geodetic GNSS receivers and low-cost receivers. The results show the following: (1) For geodetic GNSS receivers, the code ISBs of each receiver is about −0.3 m to −0.8 m, and the position deviation is reduced by 7% after correcting code ISBs. The code ISBs in the baseline with homogeneous receivers has a little influence on the positioning result, which can be ignored. The code ISBs in the baseline with heterogeneous receivers is about −0.5 m, and the position deviation is reduced by 4% after correcting code ISBs. (2) The code ISBs in the low-cost receivers are significantly larger than those in the geodetic GNSS receivers, and the impact on the positioning performance of the low-cost receivers is significantly greater than that on the geodetic GNSS receivers. After correcting the code ISBs, the position deviation of low-cost receivers can be reduced by around 12% for both undifferenced and differenced modes. (3) For low-cost receivers, correcting the code ISBs can increase the number of epochs successfully solved, which effectively improves the low-cost navigation and positioning performance. (4) The carrier-phase-smoothing method can effectively reduce the distribution dispersion of code ISBs and make the estimation of ISBs more accurate. The STD values of estimated code ISBs in geodetic GNSS receivers are reduced by about 40% after carrier-phase smoothing, while the corresponding values are reduced by about 7% in low-cost receivers due to their poor carrier-phase observation quality.