Artifacts are irreplaceable treasures of human culture, and transportation monitoring is critical for safeguarding valuable artifacts against damage during culture exchanges. However, current collision-monitoring technologies have limitations in regard to real-time monitoring, cushioning protection, and power supply requirements. Here, we present a method for constructing a smart artifact-monitoring system (SAMS) based on a porous carbon black (CB)/Ecoflex triboelectric nanogenerator (PCE-TENG) that can monitor collisions in real time and absorb vibrations during artifact transportation. The PCE-TENG is assembled using a flexible printed circuit board (FPCB) and a porous Ecoflex layer with CB powder. It exhibits cushioning protection, stretchability, pressure sensitivity, and durability. To enhance its electrical output, modifications were made to optimize the CB content and surface structure. The SAMS comprises six PCE-TENGs attached to the inner wall of the artifact transport package and enables collision monitoring and protection in different directions. Moreover, the SAMS has the capability to instantly transmit warning information to monitoring terminals in the event of improper operations, empowering carriers to promptly and efficiently safeguard artifacts by taking necessary measures. This paper presents a practical strategy for artifact transportation monitoring and package engineering that could have significant implications for the field.
Deep ultraviolet light-emitting diodes (DUV LEDs) are promising light sources for disinfection, especially during the pandemic of novel coronavirus (COVID-19). Despite much effort in the development of DUV LEDs, the device temperature and ideality factor are key parameters of devices, which are often neglected. Here, we developed a simple and convenient method to study the behavior of a 280 nm AlGaN-based DUV LED, obtaining the electrical, optical, and thermal properties within one measurement. From the experimental results, we find that the light output power and wall-plug efficiency of the AlGaN-based DUV LED are strongly affected by device temperature, ideality factor (β), and series resistance (Rs). β decreases from 9.3 to 8.1 at 40 mA when the temperature increases from 302 to 317 K. We compared these results with simulations and found that the high potential barriers inside the device and the carrier concentration in n-type or p-type layers, especially the hole concentration in p-type layers, are the two key factors for the high value of the ideality factor from the LED structure. As the device temperature increases, carriers with higher energy would overcome some potential barriers and Mg acceptor activation would be more efficient, which are beneficial for carrier transportation. However, these also lead to the carrier overflow and weaken the radiative recombination rate. The trade-off role of device temperature in carriers between transportation and overflow is needed to be considered in the future development of DUV LEDs with higher efficiency and higher brightness.