Nowadays low calcium fly ash-based geopolymer concrete can be replaced with cement-based concrete to avoid the adverse effect of manufacturing cement on the environment. Utilization of geopolymer concrete instead of traditional concrete using low calcium fly ash and nano silica reduces a significant amount of CO­₂ emission towards the atmosphere. However, the performance of geopolymer concrete is less than that of Portland cement concrete. To improve the performance of geopolymer concrete nano silica was used in the present study. In this work, geopolymer concrete was made utilizing fly ash, ground granular blast furnace slag (GGBS), and sugarcane bagasse ash. In the first instance, binary combinations i.e. fly ash and GGBS were employed as cementitious materials for the production of geopolymer concrete. In the second instance, a ternary mixture of pozzolanic material was prepared by taking 25% GGBS, 65% Fly ash, and 10% bagasse ash. In the third instance, varying percentages of nanoparticles were used for the above ternary mixture. The mechanical and durability properties of the geopolymer composite that was made earlier were tested. The compressive strength and split tensile strength of geopolymer composites were assessed for mechanical properties and a rapid chloride permeability test, water absorption test, and acid attack test were done to know about the porosity of concrete. Results showed that, with a dose of 4% nanoparticles, the durability and strength properties of the concrete had improved the most. The GCBA-N4 mixture had the highest split tensile and compressive strength was measured to be 2.91 MPa and 41.33 MPa and the rapid chloride permeability test, water absorption rate, and percentage of mass loss due to sulfate attack were found as a minimum for GCBA-N4 specimen.