Colloidal quantum dot (CQD) light-emitting diodes (LEDs) deliver a compelling performance in the visible, yet infrared CQD LEDs underperform their visible-emitting counterparts, largely due to their low photoluminescence quantum efficiency. Here we employ a ternary blend of CQD thin film that comprises a binary host matrix that serves to electronically passivate as well as to cater for an efficient and balanced carrier supply to the emitting quantum dot species. In doing so, we report infrared PbS CQD LEDs with an external quantum efficiency of ~7.9% and a power conversion efficiency of ~9.3%, thanks to their very low density of trap states, on the order of 1014 cm-3, and very high photoluminescence quantum efficiency in electrically conductive quantum dot solids of more than 60%. When these blend devices operate as solar cells they deliver an open circuit voltage that approaches their radiative limit thanks to the synergistic effect of the reduced trap-state density and the density of state modification in the nanocomposite.
Developing low‐cost photovoltaic absorbers that can harvest the short‐wave infrared (SWIR) part of the solar spectrum, which remains unharnessed by current Si‐based and perovskite photovoltaic technologies, is a prerequisite for making high‐efficiency, low‐cost tandem solar cells. Here, infrared PbS colloidal quantum dot (CQD) solar cells employing a hybrid inorganic–organic ligand exchange process that results in an external quantum efficiency of 80% at 1.35 µm are reported, leading to a short‐circuit current density of 34 mA cm−2 and a power conversion efficiency (PCE) up to 7.9%, which is a current record for SWIR CQD solar cells. When this cell is placed at the back of an MAPbI3 perovskite film, it delivers an extra 3.3% PCE by harnessing light beyond 750 nm.
Surface passivation of PbS colloidal quantum dots (QDs) with iodide has been used in highly efficient solar cells. Iodide passivation is typically achieved by ligand-exchange processes on QD films. Complementary to this approach, herein we present a nonintrusive solution-based strategy for doping QDs with iodide to further optimize solar cell performance. The doping step is applied in situ at the end of the synthesis of the QDs. The optimum precursor I/Pb ratio is found to be in the 1.5–3% range at which iodide substitutes S without excessively altering the dots’ surface chemistry. This allows for band engineering and decreasing the density of deep trap states of the QDs, which taken together lead to PbS QD solar cells with efficiency in excess of 10%.
The power conversion efficiency of colloidal PbS‐quantum‐dot (QD)‐based solar cells is significantly hampered by lower‐than‐expected open circuit voltage (VOC). The VOC deficit is considerably higher in QD‐based solar cells compared to other types of existing solar cells due to in‐gap trap‐induced bulk recombination of photogenerated carriers. Here, this study reports a ligand exchange procedure based on a mixture of zinc iodide and 3‐mercaptopropyonic acid to reduce the VOC deficit without compromising the high current density. This layer‐by‐layer solid state ligand exchange treatment enhances the photovoltaic performance from 6.62 to 9.92% with a significant improvement in VOC from 0.58 to 0.66 V. This study further employs optoelectronic characterization, X‐ray photoelectron spectroscopy, and photoluminescence spectroscopy to understand the origin of VOC improvement. The mixed‐ligand treatment reduces the sub‐bandgap traps and significantly reduces bulk recombination in the devices.