The vast amount of synthetic polymers used in packaging is putting a strain on the environment and is depleting finite, non-renewable raw materials. Abundantly available biopolymers such as alginate, chitosan and microfibrillated cellulose (MFC) have frequently been suggested in the literature to replace synthetic polymers and their barrier properties have been investigated in detail. Many studies aim to improve the properties of standalone biopolymer films. Some studies apply these biopolymers as barrier coatings on paper, but the solids content in most of these studies is quite low, which in turn would result in a high energy demand in industrial drying processes. The aim of this study is to suggest a laboratory procedure to investigate the suitability of these biopolymers at higher and such more industrially relevant solids content as potential coating materials for paper and board in order to improve their barrier properties. First, biopolymer solutions are prepared at a high solids content at which the viscosity at industrially relevant higher shear rates of 50,000 s−1 (1000 s−1 for MFC) is in the same range as a synthetic reference material (in this case ethylene vinyl alcohol EVOH) at 10 wt%. These solutions are analyzed regarding properties such as rheology and surface tension that are relevant for their coatability in industrial coating processes. Then, free-standing films are cast, and the films are characterized regarding important properties for packaging applications such as different surface, mechanical and barrier properties. Based on these results suitable biopolymers for future coating trials can be easily identified.
The demand for sustainable packaging has increased the interest in biopolymer coatings as alternatives to plastic-based barriers on paper and board. Alginate and chitosan offer promising barrier properties by improving gas barrier and grease resistance. However, their high viscosity at low solid contents presents challenges for uniform coatings, especially in possible future large-scale applications but also in existing research. This study evaluates spray coating, a non-conventional application method in the paper industry, to apply biopolymer coatings, an approach underexplored in previous studies. The effects of substrate surface energy and biopolymer surface tension on air permeability, grease resistance, and water vapor transmission were evaluated. Contact angle measurements showed that surface energy strongly influences the wetting behavior of these biopolymers, with hydrophilic substrates and lower-surface-energy liquids promoting better droplet spreading. This improved wetting resulted in better barrier performance at low application weights, further enhanced by surfactant addition. At higher application weights, surface energy had less impact on barrier properties. SEM imaging revealed drying defects at increased coat weights, affecting film integrity. These findings demonstrate the potential of spray coating as a scalable method for biopolymer application while highlighting the need for optimized drying conditions to enhance film uniformity and barrier performance.