Solar cells based on a mesoporous structure of TiO2 and the polysulfide redox electrolyte were prepared by direct adsorption of colloidal CdSe quantum dot light absorbers onto the oxide without any particular linker. Several factors cooperate to improve the performance of quantum-dot-sensitized solar cells: an open structure of the wide bandgap electron collector, which facilitates a higher covering of the internal surface with the sensitizer, a surface passivation of TiO2 to reduce recombination and improved counter electrode materials. As a result, solar cells of 1.83% efficiency under full 1 sun illumination intensity have been obtained. Despite a relatively large short circuit current (J(sc) = 7.13 mA cm(-2)) and open circuit voltage (V(oc) = 0.53 V), the colloidal quantum dot solar cell performance is still limited by a low fill factor of 0.50, which is believed to arise from charge transfer of photogenerated electrons to the aqueous electrolyte.

Among the third-generation photovoltaic devices, much attention is being paid to the so-called Quantum Dot sensitized Solar Cells (QDSCs). The currently poor performance of QDSCs seems to be efficiently patched by the ZnS treatment, increasing the output parameters of the devices, albeit its function remains rather unclear. Here new insights into the role of the ZnS layer on the QDSC performance are provided, revealing simultaneously the most active recombination pathways. Optical and AFM characterization confirms that the ZnS deposit covers, at least partially, both the TiO₂ nanoparticles and the QDs (CdSe). Photoanodes submitted to the ZnS treatment before and/or after the introduction of colloidal CdSe QDs were studied by electrochemical impedance spectroscopy, cyclic voltammetry and photocurrent experiments. The corresponding results prove that the passivation of the CdSe QDs rather than the blockage of the TiO₂ surface is the main factor leading to the efficiency improvement. In addition, a study of the ultrafast carrier dynamics by means of the Lens-Free Heterodyne Detection Transient Grating technique indicates that the ZnS shell also increases the rate of electron transfer. The dual role of the ZnS layer should be kept in mind in the quest for new modifiers for enhancing the performance of QDSCs.