Wireless communications for ingestible and implantable medical device applications are integral for the embedded systems employed to these ends. The Bluetooth protocol is of major interest given its ubiquitous nature in consumer electronic devices. Here the effectiveness of Bluetooth in such applications is examined with a custom-designed Bluetooth system. The radio frequency (RF) attenuation testing was conducted in a variety of different media, including water, meat, ballistic gel, and fat. The RF signal attenuation was found to be the highest in meat and ballistic gel, less in water and least severe in fat. The measured distances at which signal integrity was still maintained provide necessary information for designing and implementing Bluetooth based medical devices and function as evidence for the feasibility of Bluetooth enabled systems for such communications.
This paper presents the design and modeling of a novel piezoelectrically driven micro-lens actuator capable of delivering large out-of-plane displacement with a low driving voltage and fast speed. The design architecture, parameter optimization, modeling and testing of the actuator are presented. The actuator consists of six unimorph piezoelectric beams operating in a d 31 mode to symmetrically displace a micro-lens holding platform. The design methodology exploits the film residual stress levels and thicknesses to achieve an optimal initial static deflection of the actuator beams for generating the largest possible actuation sensitivity. Theoretical modeling shows an enhancement in the average actuation sensitivity from 0.975 μm/kV/cm to 1.317 μm/kV/cm by employing the methodology. The actual actuation sensitivity measured from the fabricated device shows an outstanding result of 1.45 μm/kV/cm with a resonant frequency of 2 kHz. This translates to a displacement of 145 μm at 22 V driving voltage. The static power consumption is measured to be below 3.5 mW under normal operations.
A number of design challenges are associated with in-body devices, especially ingestible capsules, including selection of operation frequency and antenna design. Operation frequency, miniaturization, gain, and interference with the environment and the internal components of ingestible capsules are all challenging factors. In this work, we design and measure the performance of miniature antennas that can be included in ingestible capsules. The meandering pattern designs are implemented with a 433 MHz center frequency which is within one of the industrial, scientific and medical (ISM) bands. The antenna patterns are rolled into cylinders to reflect their configuration inside a capsule. The effects of different antenna design features, environmental dielectric changes, and the battery locations relative to the antenna traces are explored. We show that the optimized antenna can offer acceptable performance even when the center frequency shifts due to the modulation of the dielectric constant of the media and by the insertion of batteries. Both simulations and measurements provide insight into how the meandering antenna should be designed for the desired frequency that can be expanded to other ingestible and implantable systems.