Biomass from various types of organic waste was tested for possible use in hydrogen production. The composition consisted of lignified samples, green waste, and kitchen scraps such as fruit and vegetable peels and leftover food. For this purpose, the enzymatic pretreatment of organic waste with a combination of five different hydrolytic enzymes (cellulase, amylase, glucoamylase, pectinase and xylase) was investigated to determine its ability to produce hydrogen (H2) with the hydrolyzate produced here. In course, the anaerobic rod-shaped bacterium T. neapolitana was used for H2 production. First, the enzymes were investigated using different substrates in preliminary experiments. Subsequently, hydrolyses were carried out using different types of organic waste. In the hydrolysis carried out here for 48 h, an increase in glucose concentration of 481% was measured for waste loads containing starch, corresponding to a glucose concentration at the end of hydrolysis of 7.5 g·L−1. In the subsequent set fermentation in serum bottles, a H2 yield of 1.26 mmol H2 was obtained in the overhead space when Terrific Broth Medium with glucose and yeast extract (TBGY medium) was used. When hydrolyzed organic waste was used, even a H2 yield of 1.37 mmol could be achieved in the overhead space. In addition, a dedicated reactor system for the anaerobic fermentation of T. neapolitana to produce H2 was developed. The bioreactor developed here can ferment anaerobically with a very low loss of produced gas. Here, after 24 h, a hydrogen concentration of 83% could be measured in the overhead space.
This work examines the electrochemically enhanced production of succinic acid using the bacterium Actinobacillus succinogenes. The principal objective is to enhance the metabolic potential of glucose and CO2 utilization via the C4 pathway in order to synthesize succinic acid. We report on the development of an electro-bioreactor system to increase succinic acid production in a power-2-X approach. The use of activated carbon fibers as electrode surfaces and contact areas allows A. succinogenes to self-initiate biofilm formation. The integration of an electrical potential into the system shifts the redox balance from NAD+ to NADH, increasing the efficiency of metabolic processes. Mediators such as neutral red facilitate electron transfer within the system and optimize the redox reactions that are crucial for increased succinic acid production. Furthermore, the role of carbon nanotubes (CNTs) in electron transfer was investigated. The electro-bioreactor system developed here was operated in batch mode for 48 h and showed improvements in succinic acid yield and concentration. In particular, a run with 100 µM neutral red and a voltage of −600 mV achieved a yield of 0.7 gsuccinate·gglucose−1. In the absence of neutral red, a higher yield of 0.72 gsuccinate·gglucose−1 was achieved, which represents an increase of 14% compared to the control. When a potential of −600 mV was used in conjunction with 500 µg∙L−1 CNTs, a 21% increase in succinate concentration was observed after 48 h. An increase of 33% was achieved in the same batch by increasing the stirring speed. These results underscore the potential of the electro-bioreactor system to markedly enhance succinic acid production.
The aim of this work is to study the metabolism of Actinobacillus succinogenes in greater detail with the aim of optimizing succinate production and creating a metabolic model. The inhibitory properties of various substances were first investigated. It was found that the nature and availability of the gas can have a strong influence on metabolism. By studying the effects of different gas sources, it was found that when A. succinogenes lacks a CO2 source, the metabolism completely switches to the C3 pathway. This also completely changes the path within the pathway. In the presence of CO2, significantly more formate (2.44 ± 0.04 g L−1) and significantly less acetate (1.63 ± 0.03 g L−1) was produced. In contrast, in the absence of CO2, the formate concentration was 1.94 ± 0.12 g L−1, and the acetate concentration was 2.73 ± 0.15 g L−1. In addition, larger amounts of ethanol (1.34 ± 0.28 g L−1) were produced in the absence of CO2, whereas hardly any ethanol was produced otherwise. All these results show that, in the absence of a CO2 source, the organism has to regenerate much more NADH to NAD+ via the C3 pathway. In the subsequent investigation of the CO2 source, an increase in product concentration from 1.55 ± 0.13 g L−1 to 6.11 ± 0.09 g L−1 was achieved by combining gaseous CO2 with NaHCO3. It was shown that a microaerobic environment is not sufficient to influence the metabolism of the organism towards lactate formation. Using the model, it was possible to verify the main metabolic pathways observed during experimental bioreactor runs on a 2-L scale. By conducting further modification, it is now possible to use the model to predict the effects of an external electron supply on the redox metabolism.
Carbon capture and power-to-X are becoming increasingly relevant in the context of decarbonization and supply security. Actinobacillus succinogenes is capable of transforming CO2 into succinate, whereby product formation is significantly limited by the availability of NADH. The aim of this work was to further develop a bioelectrochemical system (BES) in order to provide additional reduction equivalents and thus increase yield and titer. To this end, a new BES configuration was established. A conventional stirred tank reactor (STR) is coupled via a bypass to an H-cell, in which the redox mediator neutral red (NR) is electrochemically reduced and then returned back to the bioreactor. The indirect electron transfer decouples the electrochemical reduction from the biology and results in increased intracellular availability of NADH. The present approach resulted in an increase in yield from 0.64 g·g−1 to 0.76 g·g−1, corresponding to an increase of 18%. At the same time, a titer of 16.48 ± 0.19 g·L−1 was achieved in the BES, compared to 12.05 ± 0.18 g·L−1 in the control. The results show that the mediator-assisted, partially decoupled BES architecture significantly improves CO2-based succinate production and opens up a scalable path to the use of renewable electricity as a reduction source in power-to-X processes.
The fermentation of Actinobacillus succinogenes in bioelectrochemical systems offers a promising approach to enhance biotechnological succinate production by shifting the redox balance towards succinate and simultaneously enabling CO2 utilization. Key process parameters include the applied electric potential, electrode material, and reactor design. This study investigates the influence of various carbon fabric electrodes and applied potentials on product distribution during fermentation of A. succinogenes. Building on prior findings that potentials between −600 mV and –800 mV increase succinate production, recent data reveal that more negative potentials, beyond the water electrolysis threshold, trigger electrochemical side reactions, altering product yields. Specifically, succinate decreased from 19.76 ± 0.41 g∙L−1 to 14.1 ± 1.6 g∙L−1, while lactate rose from 0.59 ± 0.12 g∙L−1 to 3.12 ± 0.21 g∙L−1. Contrary to common assumptions, the shift is not primarily driven by oxygen formation. Instead, the results indicate that the intracellular redox potential is affected by both the applied potential and hydrogen evolution, which alters metabolic pathways to maintain redox balance. These findings demonstrate that more negative applied potentials in electro-fermentation processes can impair succinate yields, emphasizing the importance of fine-tuning electrochemical conditions in the system for optimized biotechnological succinate production.
This study investigates the efficient biogenic production of hydrogen via the thermophilic bacterium Thermotoga neapolitana, focusing on optimising process configurations to maximise yield and productivity. To determine optimal conditions, a 1 L anaerobic bioreactor with online gas analytics was designed and tested for batch, fed-batch and continuous fermentation. A maximum hydrogen production rate of 96.1 ± 1.7 Nml·L−1·h−1 was observed in the continuous reactor. The optimal dilution rate was 0.07 h−1. Each dilution rate was kept for ≥56 h fermentation time and resulted in yields of 2.7–3.0 molH2·molglucose−1. A consistently high cell viability (97%) was also observed across various dilution rates. A detailed carbon balance indicates acetate as the main by-product, closely linked to the hydrogen production pathway. Compared to fed batch and batch, the hydrogen production rate could be increased and remain constant over a longer time. In this way the continuous reactor design showed an additional method to produce hydrogen to the established ones. Fermentative hydrogen production is particularly promising when using carbohydrate containing biomass and biowaste, as it can be considered carbon dioxide neutral.