There is considerable interest in the development of new processes to extract the nickel from the oxidic nickeliferous laterite deposits, as the global nickel sulphide resources are rapidly becoming more difficult to access. In comparison to sulphide ores, where the nickel-containing mineral can be readily concentrated by flotation, nickel laterites are not amenable to significant upgrading, due to their complex mineralogy. In this paper, firstly, a brief overview of the conventional techniques used to process the nickeliferous limonitic laterites is given, as well as a review of current research in the area. Secondly, a thermodynamic model is developed to simulate the roasting process and to aid in the selection of process parameters to maximize the nickel recovery and grade and also to minimize the magnetite content of the concentrate. Thirdly, a two-stage process involving reduction roasting and thermal growth in either a tube furnace or a rotary kiln furnace, followed by magnetic separation, was investigated. Thermogravimetric, differential thermal and mineral liberation analyses techniques were utilized to further understand the process. Finally, the nickel grades and recovery results were compared to those available in the literature.
During the remelting of automobile scrap in the electric arc furnace steelmaking process, a dust is generated. This dust contains significant amounts of zinc, iron, and lead and in some cases, copper and nickel. However, the recovery of these metals is difficult, because of the complex chemical and physical characteristics of the dust. Numerous pyrometallurgical, hydrometallurgical and hybrid processes have been devised and tested for metal recovery, but only the Waelz rotary kiln process has achieved significant commercialisation. One potential process, which has received little attention in the literature, is the pyrometallurgical sulphation of the dust. In the present research, a high temperature thermodynamic model has been developed using HSC® Chemistry 7.1, to investigate the sulphation of the dust. The effects of process parameters on the conversion of the various metals into sulphates were studied. At a temperature of 600 °C, almost one hundred percent of the zinc could be converted into zinc sulphate, while about ninety-five percent of the iron could be retained as hematite. In addition, several low cost, potential sulphating reagents were evaluated.