Aminated lignin (AL) has been prepared by a Mannich reaction for the removal of Cu(II) ions from aqueous solution. Effects of pH, reaction temperature, reaction time and the initial concentration of Cu(II) ions on the adsorption capacity were investigated. The structure and properties of AL were analyzed by Fourier transform infrared spectroscopy (FT-IR), scanning electron microscopy analysis (SEM), and X-ray photoelectron spectroscopy analysis (XPS). Adsorption kinetic and isotherm models were used to illustrate the adsorption behaviors of AL. AL was more effective than enzymatic hydrolysis residues (EHR) and separated lignin (SL) in removing Cu(II) ions in aqueous solution. The adsorption capacity of AL for Cu(II) ions was better in near-neutral pH. Under the optimum adsorption conditions, the adsorption capacity of AL could reach up to 37.14 mg g−1. The pseudo-second-order model fitted the kinetic data well. The adsorption isotherm was well described by the Langmuir isotherm model. AL exhibited a good adsorption performance for recovery after three cycles. AL could be utilized as a kind of promising feedstock for high value-added products to remove Cu(II) ions in wastewater effectively.
Carbon reduction targets urge people to develop potential alternatives to traditional energy-intensive kraft pulping. To address this need, this work reported a sustainable pulping technology for eucalyptus slabs based on a deep eutectic solvent (DES) consisting of benzyltriethylammonium chloride (BTEAC) and formic acid (FA). Under mild cooking conditions (T = 130 °C, t = 2.0 h), the pulp yield reached 53.83%, and fibers had a length of 0.65 mm and a fines content of 6.21%. The physical properties of DES pulp were similar to those made by other traditional processes. Meanwhile, approximately 85% of FA and 92% of BTEAC could be reused in the improved chemical recovery process, and the cooking efficiency of recycled DES was largely maintained after 5 times of recycling. Moreover, compared with the kraft process, DES pulping could extract more lignin with high purity and narrow molecular weight distribution. The results proved that this technology could produce high-quality pulp and lignin by-products simultaneously with less energy and chemical consumption.