The wastewater generated by the pharmaceutical industry poses a risk to the environment due to undesirable characteristics such as low biodegradability, high levels of contaminants, and the presence of suspended solids, in addition to the high load of organic matter due to the presence of drugs and other emerging products in the effluent. This study aims to reduce the impact of wastewater pollution by removing amoxicillin (AMO) antibiotics as an organic pollutant. In this concept, two synthesized catalysts, NiAl2O4 and ZnO, are sensitive oxides to light energy. The prepared materials were then characterized using X-ray diffraction, UV–vis solid reflectance diffuse, Raman spectroscopy, scanning electron microscopy, BET, and ATR-FTIR spectroscopy. The effects of principal operating parameters under sunlight, namely, the percentage of the mixture of NiAl2O4 and ZnO, the pH of the medium, and the initial concentration of the antibiotic were studied experimentally to determine the optimal conditions for achieving a high degradation rate. The results showed that photodegradation is higher at a pH of 6, with a weight percentage of the mixture of 50% for both catalysts in 1 g/L of the total catalyst dose. Then, the effect of the initial concentration of AMO on the photodegradation reaction showed an important influence on the photodegradation process; as the degradation rate decreases, the initial AMO concentration increases. A high degradation rate of 92% was obtained for an initial AMO concentration of 10 mg/L and a pH of 6. The kinetic study of degradation established that the first-order model and the Langmuir–Hinshelwood (LH) mechanism fit the experimental data perfectly. The study showed the success of using heterosystem photocatalysts and sustainable energy for effective pharmaceutical removal, which can be extended to treat wastewater with other organic emerging pollutants. On the other hand, modeling was introduced using Gaussian process regression (GPR) to predict the degradation rate of AMO under sunlight in the presence of heterogeneous ZnO and NiAl2O4 systems. The model evaluation criteria of GPR in terms of statistical coefficients and errors show very interesting results and the performance of the model used. Where statistical coefficients were close to one (R = 0.9981), statistical errors were very small (RMSE = 0.1943 and MAE = 0.0518). The results suggest that the model has a strong predictive power and can be used to optimize the process of AMO removal from wastewater.
In this work, significant interest has been focused on removing pharmaceutical pollutants, i.e., oxytetracycline (OTC), which was studied through adsorption onto activated carbon (ACT) produced from households or agricultural wastes under various experimental conditions. The physicochemical properties of the produced carbon were investigated using multiple techniques. The characterization analysis highlighted an essential concentration of surface functional groups and a very developed porous structure. The adsorption process onto activated carbon occurs with a high yield at a large range of pH values varying between 4 and 8 at an optimum contact time of 2 h. It was established that the pseudo-second-order kinetic model fitted well OTC adsorption onto ACT. Moreover, the adsorption isotherm data showed that the pollutant removal process followed the Langmuir model with high regression coefficients ( ) values and important adsorption efficiency of 80% for of OTC. The displayed results consequently, the use of ACT as an adsorbent could be considered an efficient, sustainable, and low-cost alternative for pharmaceuticals-loaded wastewater treatment.
The decline in the performance of spiral-wound reverse osmosis (SWRO) membranes is frequently due to biofouling. This study focus on qualitative and quantitative diagnosis of SWRO membrane biofouling. Bacterial counts on the different surfaces of the fouled membranes were carried out. Surface enhanced Raman spectroscopy (SERS) was performed to highlight clogging materials as well as their natures and identity. The topography of the fouled membranes and the structures of biofilms were visualized by fluorescence microscopy (FM) and scanning electron microscopy (SEM). The results indicated the presence of bacteria in the different SWRO membrane areas. Those strongly adhered were significantly higher than those weakly. It varied between 26 × 105 and 262 × 105 CFU m−2. However, SERS mapping showed different fouling levels and the thickness of the fouling layer was 5 µm. Microscopic imaging revealed biotic and abiotic deposits. These data can together allow better management of the seawater desalination process.
1 January 2024 in Current Nutrition & Food Science
Background: Raman spectroscopy has evolved into an important fast, rapid, direct, and non-destructive technique that has recently been applied in different fields.Objective: The present work aims to study the theoretical bases and the experimental techniques relate to Raman spectroscopy and highlight the performance as well as the different applications of the technique.Methods: Spectroscopy, in general, is the study of the interaction between electromagnetic radiation and matter, which corresponds to the emission or transmission of energy in the form of a wave at a given frequency. Raman spectroscopy is based on the inelastic diffusion of photons on electrons. The change in electron energy level leads to different modes of vibration of a molecule. These different vibration modes occur at specific frequencies for each molecule.Results: Raman spectroscopy is used in chemistry as a tool to identify molecules in a sample. Indeed, each Raman peak is associated with a vibration mode of a molecule; it is considered as a more useful approach to monitor the chemical parameters of samples tested in several fields, especially in food safety.Conclusion: This review covers the current research status and prospects of Raman spectroscopy. The Raman effect is considered from the time of its discovery as a great gift for chemists because it contributes to a better characterization of the structure of matter.