This study aimed to develop and optimize a novel biochar-based fertilizer composed of rice husk biochar and urea–hydrogen peroxide (UHP), which can simultaneously slowly release nitrogen and immobilize cadmium (Cd). Response surface methodology (RSM) was adopted to optimize the fertilizer formulation with the lowest nitrogen release rate. Under the optimized conditions, the cumulative nitrogen release rate of the biochar-based fertilizer was 17.63%, which was significantly lower than that of ordinary fertilizer. Elementary analysis, scanning electron microscopy (SEM) images, and Fourier transform infrared (FTIR) spectroscopy proved that UHP attached to the porous structures of the biochar. The adsorption test showed that the adsorption of Cd onto biochar-based fertilizer quickly reached equilibrium with an equilibrium adsorbing quantity (Q_e) of 6.3279 mg·g⁻¹ with an initial concentration of 10 mg·L⁻¹. Compared to original biochar, the Cd immobilization ability of biochar-based fertilizer was significantly better. The adsorption of Cd on biochar-based fertilizer is mainly based on a monolayer adsorption behavior. Finally, improved crop growth was demonstrated by pot experiments, which showed a significant increase in the biomass of cabbage. The concept and findings presented in this study may be used as references in developing a novel biochar-based fertilizer for simultaneously enhancing crop yield and reducing environmental risk.

The disposal of a large amount of biogas residue from anaerobically digested food waste is a burden for biogas production. The aim of this work was to investigate biogas residue as a potential feedstock, by preparing biochar at a broad pyrolysis temperature range of 400–900 °C. The properties required for phosphorus recovery and soil amendment application were evaluated. Biogas residue collected from an urban food waste treatment plant was pyrolyzed in a laboratory scale reactor. It was found that by increasing the pyrolysis temperature, the yield of biochar decreased and the pH, electrical conductivity and Brunauer–Emmett–Teller surface area increased. The amount of phosphorus adsorbed onto the biogas residue-derived biochar (BRB) at 900 °C was larger than that of other kinds of biochar. The kinetics of phosphorus (P) adsorption on BRB could be described by the pseudo-second-order equation. The pot experiments showed that the resulting biochar is beneficial for the growth of cabbage. Overall, turning solid residue from the anaerobic digestion of food waste for biogas production into biochar shows good prospects as a means of solving the disposal problem, while creating new markets for food waste biogas residue.

Anaerobic digestion (AD) was utilized to treat the ever-growing amount of organic fraction of municipal solid waste (OFMSW) generated due to population growth and the expansion of the global economy. The widespread application of AD has led to a continuous increase in residual solid digestate that necessarily requires further disposal. Improving AD efficiency and reducing the large amount of digestate is necessary. This study investigated the chemical and physical characteristics of biochar derived from digestate at different pyrolysis temperatures (300 °C, 500 °C, and 700 °C), as well as corn stover biochar at 500 °C, and their effects on AD performance. The pH value of the biochar increased with an increase in pyrolysis temperature while the electrical conductivity decreased. Macropores dominated the biochar’s pore size, and decreased with an increased pyrolysis temperature. The biochar preparation temperature significantly influenced the AD efficiency. Biochar prepared at 700 °C outperformed the other groups, improving the biogas production yields by 10.0%, effectively shortening the lag time, and increasing the average chemical oxygen demand (COD) degradation rate by 14.0%. The addition of biochar (700 °C) and corn stover biochar increased the relative abundance of the volatile fatty acid (VFAs)-oxidizing bacteria Syntrophomonadaceae, which expedited the acid conversion in AD systems. Biochar facilitated direct interspecies electron transfer between DMER64 and Trichococcus with Methanosaeta, enhancing the biogas production performance. These findings confirmed that the biochar derived from digestate promoted biogas production and acid conversion in the AD system of OFMSW. Furthermore, biochar has an improved AD stability, which represents a promising approach to recycling digestate.

Effective management of fecal pollutants in rural sanitation is crucial for environmental health and public safety, especially in developing regions. In this study, temporal and regional variations in nutrient elements, heavy metals, pathogenic microorganisms (PMs), and antibiotic resistance genes (ARGs) of fecal samples from rural toilets in China were investigated. The moisture contents of the fecal samples average 92.7%, decreasing seasonally from 97.4% in summer to 90.6% in winter. The samples’ pH values range from 6.5 to 7.5, with a slight decrease in winter (6.8), while their electrical conductivity varies from 128.1 to 2150 μs/cm, influenced by regional diets. Chromium (9.0–49.7 mg/kg) and copper (31.9–784.4 mg/kg) levels vary regionally, with higher concentrations in Anhui and Guangxi Provinces due to dietary and industrial factors. Zinc contents range from 108.5 to 1648.9 mg/kg, with higher levels in autumn and winter, resulting from agricultural practices and Zn-containing fungicides, posing potential health and phytotoxicity risks. Seasonal and regional variations in PMs and ARGs were observed. Guangxi Province shows the high PM diversity in summer samples, while Jiangsu Province exhibits the high ARGs types in autumn samples. These findings highlight the need for improved waste management and sanitation solutions in rural areas to mitigate environmental risks and protect public health. Continued research in these regions is essential to inform effective sanitation strategies.