The aim of the present study was to assess the drinking water quality in the selected urban areas of Lahore and to comprehend the public health status by addressing the basic drinking water quality parameters. Total 50 tap water samples were collected from groundwater in the two selected areas of district Lahore i.e., Gulshan-e-Ravi (site 1) and Samanabad (site 2). Water samples were analyzed in the laboratory to elucidate physico-chemical parameters including pH, turbidity, temperature, total dissolved solids (TDS), electrical conductivity (EC), dissolved oxygen (DO), total hardness, magnesium hardness, and calcium hardness. These physico-chemical parameters were used to examine the Water Quality Index (WQI) and Synthetic Pollution Index (SPI) in order to characterize the water quality. Results of th selected physico-chemical parameters were compared with World Health Organization (WHO) guidelines to determine the quality of drinking water. A GIS-based approach was used for mapping water quality, WQI, and SPI. Results of the present study revealed that the average value of temperature, pH, and DO of both study sites were within the WHO guidelines of 23.5 °C, 7.7, and 6.9 mg/L, respectively. The TDS level of site 1 was 192.56 mg/L (within WHO guidelines) and whereas, in site 2 it was found 612.84 mg/L (higher than WHO guidelines), respectively. Calcium hardness of site 1 and site 2 was observed within the range from 25.04 to 65.732 mg/L but, magnesium hardness values were higher than WHO guidelines. The major reason for poor water quality is old, worn-out water supply pipelines and improper waste disposal in the selected areas. The average WQI was found as 59.66 for site 1 and 77.30 for site 2. Results showed that the quality of the water was classified as “poor” for site 1 and “very poor “ for site 2. There is a need to address the problem of poor water quality and also raise the public awareness about the quality of drinking water and its associated health impacts.
Mentha longifolia is frequently utilized as a natural treatment in conventional medicine to treat diverse illnesses, including gastrointestinal, respiratory, and inflammatory disorders. The present study aimed to unveil the phenolic composition, as well as the antioxidant, antihemolytic, and antimicrobial potential of different parts of Mentha longifolia . HPLC‐DAD analysis was employed to identify the phenolic components of extracts from different plant parts. The total flavonoid and phenolic contents were measured. Four assays were conducted to assess the antioxidant capacity in vitro, including DPPH, ABTS, RP, and TAC assays. The antihemolytic potential of different parts of M. longifolia was also evaluated. The minimum inhibitory concentration (MIC) was determined using the microdilution method, and the minimum bactericidal concentration (MBC) was assessed. Thirteen compounds were identified in M. longifolia extracts, among them kaempferol, quercetin, ferulic acid, and gallic acid. However, the aerial part of M. longifolia (leaves and stem) and root extract contained a high polyphenol content and exhibited nutritional properties. Leaf extract comprises a high level of flavonoid content combined with significant antioxidant potency and demonstrated excellent antibacterial and antifungal activity. Moreover, a significant antihemolytic capacity was observed in the root, stem, and seed extracts. Based on the findings of the current study, M. longifolia extracts exhibited high antihemolytic power along with antioxidant and antimicrobial properties, suggesting their potential use in the development of plant‐based drugs in the future.
The global economy and public health are seriously at risk because of the COVID-19 outbreak brought on by the SARS-CoV-2. Currently, there is no specific medication available to treat COVID-19 patients. A quick method used to find out the treatment of newly developing infectious diseases like SARS COV-2 by drug repurposing. Metronidazole (3-methyl-5-nitroimidazole) is a synthetic, azomycin derivative having strong bacteriocidal and antiparasitic properties. Metronidazole (MTZ) derivatives are commercially broad spectrum containing pertinent antibacterial activity and a reasonable safety profile. MTZ structures were designed using chemdraw professional and subjected to field base and atom base QSAR and displayed good results by identifying 9 compounds as active. Molecular docking was performed with 9 proteins from which highest docking score was ranged from − 6.305 to − 8.044 of MT35 with 7aot as compared to standard drug (Lopinavir, showed docking score − 5.504 with same protein). Docking was further validated by redocking by RMSD score in range of 2 Å. MMGB/SA results showed the negative binding energy values of docked protein–ligand complexes comparable to standard drug and MD stimulation were also performed for the structure flexibility showed 1.00 Å RMSF for three protein at maximum fluctuation. Selected drug (MT35) showed good ADME properties which may need to be synthesized followed by in vitro and in vivo study against SARS-CoV-2. Graphical Abstract
The present study deals with the production of cellulase-free endoxylanase by Aspergillus niger ISL-9 using wheat bran as a solid substrate. Endoxylanase was produced under a solid-state fermentation. Various growth parameters were optimized for the improved production of the enzyme. The Substrate level of 15 g was optimized as it provided the fungus with balanced aeration and nutrition. Among the six moisture contents investigated, Moisture Content 5 (MC5) was optimized (g/l: malt extract, 10; (NH4)2HPO4, 2.5; urea, 1.0) and 10 mL of MC5 was found to give the highest production of endoxylanase. The pH and time of incubation were optimized to 6.2 and 48 h respectively. The Inoculum size of 2 mL (1.4 × 106 spores/mL) gave the maximum enzyme production. After optimization of these growth parameters, a significantly high endoxylanase activity of 21.87 U/g was achieved. Very negligible Carboxymethylcellulase (CMCase) activity was observed indicating the production of cellulase-free endoxylanase. The notable finding is that the endoxylanase activity was increased by 1.4-fold under optimized conditions (p ≤ 0.05). The overall comparison of kinetic parameters for enhanced production of endoxylanase by A. niger ISL-9 under Solid State Fermentation (SSF) was also studied. Different kinetic variables which included specific growth rate, product yield coefficients, volumetric rates and specific rates were observed at 48, 72 and 96 h incubation time and were compared for MC1 and MC5. Among the kinetic parameters, the most significant result was obtained with volumetric rate constant for product formation (Qp) that was found to be optimum (1.89 U/h) at 72 h incubation period and a high value of Qp i.e.1.68 U/h was also observed at 48 h incubation period. Thus, the study demonstrates a cost-effective and environmentally sustainable process for xylanase production and exhibits scope towards successful industrial applications.
Recent study aimed to fabricate pH responsive, intelligent, Pluronic F127 based polymeric system for controlled delivery of Famciclovir. Nine formulations were developed through free radical polymerization. Polymeric system exhibited pH dependent swelling by showing higher degree of swelling in simulated intestinal fluid of pH 7.4 while negligible swelling in simulated gastric fluid of pH 1.2. Drug loading increased with increase in percent water content. Famciclovir loading percent was found in range of 60.892% to 73.741%. In FTIR spectra, characteristic peaks were achieved confirming the successful grafting of drug in polymeric system. PXRD results demonstrated the conversion of crystalline nature of Famciclovir into an amorphous one in the loaded hydrogel. SEM confirmed the porous nature of hydrogel. Famciclovir loaded hydrogel showed superior thermal behavior as compared to the drug alone. In vitro Famciclovir release studies unveiled small quantity of drug release in simulated gastric fluid (25.55–34.89%) while maximal release in simulated intestinal fluid (90.12–99.13%) for 36 h was documented thereby confirming pH regulated release. Application of DD solver revealed that PLMA hydrogels followed zero order while First order was being followed by Famciclovir marketed tablet. No toxicity signs were observed in rabbits establishing the biosafety of system. Hence, the results suggest that Pluronic based polymeric system can act as promising carrier for controlled, site specific delivery of Famciclovir in intestine for prolonged period thereby reducing its dosing frequency and minimizing gastric side effects for treating Herpes and Varicella zoster infections.
Understanding the distribution of the plant species of an unexplored area is the utmost need of the present-day. In order to collect vegetation data, Quadrat method was used having size of 1 m2. The composite soil samples from each site were tested for various edaphic properties. PC-ORD v.5 was used for the classification of the vegetation while CANOCO v.5.1 was used for ordination of the data and to find out the complex relationship between plants and environment. Survey was conducted during summer season and a total of 216 herbaceous species were recorded from forty different sites of District Kohat, Pakistan. Cluster Analysis (CA) and Two-Way Cluster Analysis (TWCA) classified the vegetation of forty sites into six major plant groups i.e., 1. Paspalum paspalodes, Alternanthera sessilis, Typha domingensis, 2. Cynodon dactylon, Parthenium hysterophorus, Brachiaria ramosa, 3. Cynodon dactylon, Eragrostis minor, Cymbopogon jwarancusa, 4. Cymbopogon jwarancusa, Aristida adscensionis, Boerhavia procumbens, 5. Cymbopogon jwarancusa, Aristida adscensionis, Pennisetum orientale and 6. Heteropogon contortus, Bothriochloa ischaemum, Chrysopogon serrulatus. They were named after the dominant species based on their Importance Value (IV). The detrended correspondence analysis (DCA) analysis further confirmed the vegetation classification. Canonical correspondence analysis (CCA) indicated that the species distribution in the area was strongly affected by various environmental factors including status, soil characteristics, topography and altitude.