Electrocatalytic gas sensors belong to the family of electrochemical solid state sensors. Their responses are acquired in the form of I-V plots as a result of application of cyclic voltammetry technique. In order to obtain information about the type of measured gas the multivariate data analysis and pattern classification techniques can be employed. However, there is a lack of information in literature about application of such techniques in case of standalone chemical sensors which are able to recognize more than one volatile compound. In this article we present the results of application of these techniques to the determination from a single electrocatalytic gas sensor of single concentrations of nitrogen dioxide, ammonia, sulfur dioxide and hydrogen sulfide. Two types of classifiers were evaluated, i.e. linear Partial Least Squares Discriminant Analysis (PLS-DA) and nonlinear Support Vector Machine (SVM). The efficiency of using PLS-DA and SVM methods are shown on both the raw voltammetric sensor responses and pre-processed responses using normalization and auto-scaling
Air pollution is a one of the major concern of civilized world, which has a significant impact on human health and the environment. Recent studies highlight that the exposure to polluted air can increase the incidence of diseases and deteriorate the quality of life. Hence, it is necessary to develop tools for real-time air quality monitoring. Electronic-nose systems based on sensors are an interesting and promising technology in the field of monitoring environmental pollution. However, real-life usage in monitoring of outdoor air is connected with several challenges, such as temperature or humidity changes affecting sensor response. In this study, a performance of the three electronic nose systems based on semiconducting gas sensors only, amperometric gas sensors only and both type of sensors in outdoor air quality is evaluated. Toxic gas concentration prediction ability of these three e-noses is compared with the reference results from the stationary station of air monitoring system.
The concentration or the partial pressure of oxygen in an environment can be determined using different measuring principles. For high temperature measurements of oxygen, ceramic-based sensors are the most practical. They are simple in construction, exploration and maintenance. A typical oxygen potentiometric sensor consists of an oxygen ion conducting solid electrolyte and two electrodes deposited on the two sides of the electrolyte. In this paper different structures of potentiometric oxygen sensors with a solid state reference electrode were fabricated and investigated. The fabricated structures consisted of oxygen ion conducting solid electrolyte from yttria stabilized zirconia, a sensing platinum electrode and nickel-nickel oxide reference electrode. The mixture of nickel-nickel oxide was selected as the reference electrode because it provides reliable electrochemical potential in contact with oxygen conducting electrolyte. To avoid oxidation of nickel the reference electrode is sealed from ambient and the mixture of nickel-nickel oxide was formed electrochemically from nickel oxide after sealing. The effectiveness of the sealing quality and the effectiveness of nickel-nickel oxide mixture formation was investigated by impedance spectroscopy.
Low-temperature deposition of electroceramic thin films allows the construction of new devices and their integration with existing large-scale fabrication methods. Developing a suitable low-cost deposition method is important to further advance the development of microdevices. In this work, we deposited a 1-μm-thick La0.6Sr0.4CoO3−δ (LSC) perovskite with high electrical conductivity on sapphire substrates at 400°C and analyzed its electrical, morphological and structural properties as a function of temperature in the range of 400–1100°C. The results show that spray pyrolysis can be used to deposit high-quality reproducible layers with the desired chemical and phase composition. Upon heating to around 600°C, the residual C–O and C=O species are removed, and the deposited layers crystallize and become conducting. The dependence of electrical conductivity versus processing temperature has a complex character—the maximum conductivity is found for layers processed at 800°C. An analytical model of stress distribution was used to predict stress to which the bi-layer material would be exposed to while being cooled down from the annealing temperature to room temperature. The high electronic conductivity and high-quality microstructure of the LSC layers, which can be adjusted with the appropriate heat treatment procedure, make them suitable for applications in electrochemical devices applied in integrated energy modules, including electrodes or contacts.