Communications in Computational Physics (CiCP) publishes original research and survey papers of high scientific value in computational modeling of physical problems. Results in multi-physics and multi-scale innovative computational methods and modeling in all physical sciences will be featured.CiCP is a refereed international, interdisciplinary journal edited by a group of world-wide leading scientists in diverse fields to guarantee its highest standard. The journal is published in a timely fashion in printed and electronic forms.

Improved power take-off (PTO) controller design for wave energy converters is considered a critical component for reducing the cost of energy production. However, the device and control design process often remains sequential, with the space of possible final designs largely reduced before the controller has been considered. Control co-design, whereby the device and control design are considered concurrently, has resulted in improved designs in many industries, but remains rare in the wave energy community. In this paper we demonstrate the use of a new open-source code, WecOptTool , for control co-design of wave energy converters, with the aim to make the co-design approach more accessible and accelerate its adoption. Additionally, we highlight the importance of designing a wave energy converter to maximize electrical power, rather than mechanical power, and demonstrate the co-design process while modeling the PTO's components (i.e., drive-train and generator, and their dynamics). We also consider the design and optimization of causal fixed-structure controllers. The demonstration presented here considers the PTO design problem and finds the optimal PTO drive-train that maximizes annual electrical power production. The results show a 22.0% improvement in the optimal controller and drive-train co-design over the optimal controller for the nominal, as built, device design.

To promote and support the wave energy industry, a wave energy converter (WEC) design tool, WEC-Sim, is being developed by Sandia National Laboratories and the National Renewable Energy Laboratory. In this paper, the WEC-Sim code is used to model a point absorber WEC designed by the U.S. Department of Energy’s reference model project. Preliminary verification was performed by comparing results of the WEC-Sim simulation through a code-to-code comparison, utilizing the commercial codes ANSYS-AQWA, WaveDyn, and OrcaFlex. A preliminary validation of the code was also performed by comparing WEC-Sim simulation results to experimental wave tank tests.

Wave energy converters (WECs) are commonly designed and analyzed using numerical models that combine multibody dynamics with hydrodynamic models based on the Cummins equation and linearized hydrodynamic coefficients. These modeling methods are attractive design tools because they are computationally inexpensive and do not require the use of high-performance computing resources necessitated by high-fidelity methods, such as Navier-Stokes computational fluid dynamics. Modeling hydrodynamics using linear coefficients assumes that the device undergoes small motions and that the wetted surface area of the devices is approximately constant. WEC devices, however, are typically designed to undergo large motions to maximize power extraction, calling into question the validity of assuming that linear hydrodynamic models accurately capture the relevant fluid-structure interactions. In this paper, we study how calculating buoyancy and Froude-Krylov forces from the instantaneous position of a WEC device changes WEC simulation results compared to simulations that use linear hydrodynamic coefficients. First, we describe the WEC-Sim tool used to perform simulations and how the ability to model instantaneous forces was incorporated into WEC-Sim. We then use a simplified one-body WEC device to validate the model and to demonstrate how accounting for these instantaneously calculated forces affects the accuracy of simulation results, such as device motions, hydrodynamic forces, and power generation. Other aspects of WEC-Sim code development and verification are presented in a companion paper [1] that is also being presented at OMAE2014.