The conversion of agricultural and forestry waste biomass materials into bio-oil by mild hydro-thermal technology has a positive effect on extending the agricultural industry chain and alleviating the world energy crisis. The interaction investigation of biomass components during bio-oil formation can be significant for the efficient conversion of lignocellulose when different raw materials are fed together. In this paper, a bio-oil pyrolysis behavior (thermogravimetric analysis, TG) perspective component interaction investigation of cotton stalks under low-temperature hydro-thermal conversion (220 °C) was studied. Cellulose, hemi-cellulose, lignin, and protein were used as lignocellulose model components, by their simple binary blending and multi-variate blending and combined with thermo-gravimetric analysis and gas chromatography-mass spectrometry (GC-MS) characterization and analysis. The interaction of different model components and real biomass raw material components in the hydro-thermal process was explored. Results showed that the components of hydro-thermal bio-oil from cotton stalks were highly correlated with the interactions between cellulose, hemi-cellulose, lignin, and protein. During the hydro-thermal process, cellulose and hemi-cellulose inhibit each other, which reduces the content of ketones, aldehydes, ethers, and alcohols in bio-oil. Interaction between cellulose and lignin was obvious, which promotes the formation of oligomers, such as ketones, aldehydes, esters, phenols, and aliphatic, while inhibiting the production of aromatic and multi-hybrid compounds. Otherwise, there was no obvious interaction effect between hemi-cellulose and lignin or between lignin and protein. This research will guide the industrialization of lignocellulose, especially the possible co-feed hydro-thermal conversion technology.

The oxidative cracking of diformyltricyclodecanes (DFTD) to C6–C8 alkenes and alkenes were systematically studied in this work. A series of experiments was performed over a broad range of conditions (temperature: 40–60 °C; oxygen pressure: 0–1.0 Mpa; reaction time: 5–90 min, solvent selection) for exploring the reaction route and mechanism. Results show that the higher temperature and oxygen pressure, as well as tetrahydrofuran (THF) as solvent are of benefit to the generation of cracking products. In addition, the kinetics of this reaction was explored by the dynamic fitting. The obtained kinetics parameters demonstrate that the transformation of intermediate to cracking products possesses higher activation energy than to dicarboxyltricyclodecaneacids (DCTDA), showing that higher temperature is conducive to the generation of DFTD cracking products. This work firstly demonstrated that DFTD could be formed into C6-C8 alkenes containing the same as gasoline compound by the oxidative cracking, suggesting that the by-product of petroleum and coal could be transferred into fuels; this expanded the application of DCPD and will have significant and positive influence on the petroleum and coal chemical industry.