The five independent elastic moduli of single-crystalline hexagonal boron nitride (-BN) are determined using inelastic x-ray scattering. At room temperature the elastic moduli are in units of GPa , , , , and . Our experimental results are compared with predictions of ab initio calculations and previously reported incomplete datasets. These results provide solid background for further theoretical advances and quantitative input to model elasticity in boron nitride (BN) nanotubes.
Squeezing into the third dimension: Cuprate superconductors are known to harbor charge order in part of their phase diagram. Curiously, the order has a two-dimensional (2D) character at zero magnetic field, whereas a 3D order appears at high fields. Kim et al. now show that in a yttrium-based cuprate, a 3D charge order can be induced even at zero magnetic field. The authors compressed the material along one direction and measured a large inelastic x-ray scattering signal that was consistent with the formation of a 3D order. The measurements suggest that the induced order is associated with an optical lattice mode in the material. Science , this issue p. 1040
A new diffractometer is now available to the general user community at the ESRF. The new diffractometer is a side station of the high-resolution inelastic X-ray scattering spectrometer on beamline ID28 and is located in the same experimental hutch. Both instruments can be operated simultaneously. The new diffractometer combines a fast and low-noise hybrid pixel detector with a variable diffraction geometry. The beam spot on the sample is 50 µm × 50 µm, where focusing is achieved by a combination of Be lenses and a KB mirror. Wavelengths from 0.5 to 0.8 Å can be used for the diffraction experiments. The setup is compatible with a variety of sample environments, allowing studies under non-ambient conditions. The diffractometer is optimized to allow a rapid survey of reciprocal space and diffuse scattering for the identification of regions of interest for subsequent inelastic scattering studies, but can also be employed as a fully independent station for structural studies from both powder and single-crystal diffraction experiments. Several software packages for the transformation and visualization of diffraction data are available. An analysis of data collected with the new diffractometer shows that the ID28 side station is a state-of-the-art instrument for structural investigations using diffraction and diffuse scattering experiments.
1 February 2020 in Acta crystallographica Section B, Structural science, crystal engineering and materials