The Gonghe Basin, situated on the northeastern margin of the Qinghai–Tibet Plateau, is a strike-slip pull-apart basin that has garnered considerable attention for its abundant high-temperature geothermal resources. However, as it is located far from the Himalayan geothermal belt, research on the geothermal resources in the Gonghe Basin has mainly focused on the heat source mechanism, with less attention given to the distribution and resource potential of hot dry rock. In this project, a comprehensive approach combining geological surveys, geophysical exploration, geochemical investigations, and deep drilling was employed to analyze the stratigraphic structure and lithological composition of the Gonghe Basin, establish a basin-scale three-dimensional geological model, and identify the lithological composition and geological structures within the basin. The model revealed that the target reservoirs of hot dry rock in the Gonghe Basin exhibit a half-graben undulation pattern, with burial depths decreasing from west to east and reaching a maximum depth of around 7000 m. Furthermore, the distribution of the temperature field in the area was determined, and the influence of temperature on rock density and specific heat was investigated to infer the thermal properties of the deep reservoirs. The Qiabuqia region, situated in the central-eastern part of the basin, was identified as a highly favorable target area for hot dry rock exploration and development. The volume method was used to evaluate the potential of hot dry rock resources in the Gonghe Basin, which was estimated to be approximately 4.90 × 10²² J, equivalent to 1.67 × 10¹² t of standard coal, at depths of up to 10 km.

The Northern Jiangsu Basin (NJB), located at the northeast edge of the Yangtze block, is not only rich in oil and gas resources but also contains abundant geothermal resources. Nevertheless, the distribution of geothermal resources at medium depth in the NJB is still unclear due to its complex geological structure and tectonic–thermal evolution process, which restricts its exploitation and utilization. The characteristics of the geothermal field and distribution of geothermal reservoirs within the NJB are preliminarily analyzed based on available temperature measurements and geothermal exploration data. The prospective areas for the exploration of deep geothermal resources are discussed. The analysis results show that (1) Mesozoic–Paleozoic marine carbonate rocks are appropriate for use as principal geothermal reservoirs for the deep geothermal exploration and development within the NJB; (2) the geothermal field is evidently affected by the base fluctuation, and the high-temperature area is mainly concentrated at the junction of the Jianhu uplift and Dongtai depression; (3) the southeast margin of Jinhu sag, Lianbei sag, the east and west slope zone of Gaoyou sag, the low subuplifts within the depression such as Lingtangqiao–Liubao–Zheduo subuplifts, Xiaohai–Yuhua subuplifts and the west of Wubao low subuplift, have good prospects for deep geothermal exploration.

As a clean and renewable energy source with huge reserves, hot dry rock geothermal resources have received wide attention. The geothermal field plays a crucial role in studying the heat source mechanism of hot dry rock, defining target areas, and evaluating resources. In this study, the three-dimensional structural inversion of the Gonghe Basin is carried out using magnetotelluric sounding, and the Curie isothermal surface is obtained by analyzing regional aeromagnetic data. By coupling low-resistance and high-conductivity zones with temperature distribution and integrating the Curie isothermal surface with high-temperature anomalies of some melts, we constructed an initial temperature field model based on comprehensive geophysical data. The temperature field model of the Gonghe Basin is established by using the adaptive finite-element temperature conduction control equation and the constraints of the temperature data from geothermal wells. The temperature field model provides a basis for the future exploration of hot dry rock resources in the Gonghe area.

Induced seismicity is a recognized challenge in hot dry rock (HDR) geothermal development. Based on a systematic review of previous studies on induced seismicity mechanisms, characteristics, risk assessment, and mitigation measures, we compiled publicly available data from 13 HDR projects worldwide. Our statistical analysis shows that felt earthquakes occurred in 62% of the projects, and a post-injection “tailing effect” was observed in 54% of the projects. The spatial influence range of induced seismicity is typically within 2 km of the injection well, and the duration of the “Kaiser effect” varies from months to years depending on local conditions. A cross-site comparison of injection parameters suggests that the maximum wellhead pressure may be a more useful indicator than injected volume for estimating the largest possible earthquake magnitude, especially when comparing different tectonic settings. Furthermore, we examine the applicability and limitations of b-value trends, seismogenic indices, and existing maximum magnitude prediction models in seismic risk assessment. Dynamic adjustment of injection parameters based on real-time risk indicators, combined with safer injection schemes, may represent an important research direction for improving the conventional traffic light system. These findings provide a data-driven basis for site-specific safety management of HDR development.