Latest advancements in transparent ceramics development have ensured a mainstream research interest in this family of materials. Crystallization of glass into transparent ceramics has emerged recently as an alternative but complementary trajectory for obtaining transparent ceramics, which circumvents some of the long-standing technical difficulties associated with traditional transparent ceramics processing. The full bulk glass crystallization allows for the synthesis of high-density/low-porosity transparent ceramics of stable and metastable phases or even non-cubic structures, which are difficult to obtain using the traditional processing methods. This article presents a brief survey of the science of the transparency of ceramics and a detailed overview of the materials systems and techniques used for the preparation of transparent ceramics through the glass crystallization route. Finally, the review provides authors' insights into the future trends and research directions aimed to encourage a widespread application of glass crystallization into transparent ceramics in the fabrication of next-generation materials.
Hexagonal boron nitride (hBN) ceramics are expected to have wide applications at high temperatures as both a structural and functional material. However, because of its flake structure and general inertness, it is currently impossible to sinter hBN powder to a dense bulk (with a relative density of above 96%) even at 2000 °C. Here, we report dense bulk hBN with 97.6% theoretical density achieved at a lower preparation temperature (1700 °C) via a self-densifying mechanism without sintering additives. During the sintering process, cubic boron nitride particles incorporated into the hBN flake powders transform into BN onions with a significant volume increase, thus filling in voids among the hBN flakes and highly densifying the hBN bulks. The resulting dense hBN ceramics possess 2–3 times the strength of traditional hBN ceramics. This phase-transition-induced volume expansion strategy could lead to dense sintered compacts with high performance in other ceramic systems.
In this study we fabricated, for the first time, magnesium gallate (MgGa2O4, a partially inverted spinel) transparent ceramics, both undoped and doped with 1 at% Ni. The specimens were derived from in-house prepared powder, with a crystallite size of ∼10 nm (by wet chemistry) and densified by pulsed electric current sintering (PECS; peak temperature 950 °C for 90 min). Densification levels of 99.84% and 99.52% of theoretical density were attained for doped and undoped materials, respectively. Doping with Ni was seen to marginally improve the densification level. Quite transparent specimens were produced: the best showing transmission of ∼89% of the theoretical level (thickness t = 0.85 mm). The absorption spectra revealed that the dopant was accumulated as Ni2+ in the octahedral sites of the lattice, as occurs in single-crystal specimens. After excitation at 980 nm, the doped disks exhibited a wide fluorescence band centered at 1264 nm.
6 August 2015 in Journal of the American Ceramic Society
Fabrication of single crystals has long been limited to melt- and solution-growth techniques. However, in recent years solid-state single crystal growth (SSCG) has appeared as a promising alternative to the conventional techniques due to its cost-effectiveness and simplicity in terms of processing. Moreover, the SSCG technique has enabled the fabrication of single crystals with complex chemical compositions and even incongruent melting behavior. A recently proposed mechanism of grain boundary migration known as the “mixed control mechanism” and the associated principles of microstructural evolution represent the basis of the SSCG technique. The mixed control mechanism has been successfully used to control the key aspects of the SSCG technique, which are the grain growth and the development of the microstructure during the conversion process of the single crystal from the polycrystalline matrix. This paper explains in brief basis of the mixed control mechanism and the underlying principles of microstructural evolution in polycrystalline materials and provides a comprehensive overview of the most recent research on single crystal materials fabricated via the solid-state single crystal growth technique and their properties.