In this paper, we provide updates on our recent work on the theory of microwave remote sensing for applications in remote sensing of soil moisture and snow water equivalent (SWE). The three topics are the following. (i) For the effects of forests and vegetation, we developed the hybrid method of NMM3D full-wave simulations over the vegetation field and forest canopies. In the hybrid method, we combined the use of commercial off-the-shelf software and wave multiple scattering theory (W-MST). The results showed much larger transmission than classical radiative transfer theory. (ii) In signals of opportunity at L-band and P-band, which are radar bistatic scattering in the vicinity of the specular direction, we developed the Analytical Kirchhoff solution (AKS) and Numerical Kirchhoff approach (NKA) in the calculations of coherent waves and incoherent waves. We also took into account of the effects of topographical elevations and slopes which have strong influences. (iii) In rough surface radar backscattering, we used the volume integral equation approach for NMM3D full-wave simulations for soil surfaces with kh up to 15. The simulations were calculated for the X-band and Ku-band and the results showed saturation effects. The simulation results can be applied to microwave remote sensing of SWE at these two frequencies.
27 September 2022 in IEEE Transactions on Geoscience and Remote Sensing
A comparison of three different electromagnetic scattering models for land surface delay-Doppler maps (DDMs) obtained from global navigation satellite system reflectometry (GNSS-R) along a Cyclone Global Navigation Satellite System (CYGNSS) track in the San Luis Valley, Colorado, USA, is presented. The three models are the analytical Kirchhoff solutions (AKS), the Soil And VEgetation Reflection Simulator (SAVERS), and the improved geometrical optics with topography (IGOT). Common inputs to the three models were defined by using field samples of soil moisture and texture, soil surface roughness measurements, and a digital elevation model (DEM). The resulting peak reflectivity profiles of the models and the CYGNSS data all had a range of 10 dB along the selected track, mainly due to the influence of topography. The reflectivities obtained from all three models agreed with one another within 2.4 dB along the full length of the track. The models also showed general agreement with the corresponding CYGNSS data, although the modeled profiles were higher than CYGNSS Science Data Record Version 3.1 by an average of 5 dB and also smoother. Additional characterization of fine-scale surface roughness is identified as an area for future work to improve model fidelity. An intercomparison of DDM structure for three selected acquisitions is also provided.
In studying the mass balance of polar ice sheets, fluctuations in firn density near the surface is a major uncertainty. In this paper, we explore these variations at locations on the Greenland Ice Sheet and at the Dome C location in Antarctica. Borehole in situ measurements, snow radar echoes, microwave brightness temperatures, and modeling results from the Community Firn Model (CFM) are used. It is shown that firn density profiles can be represented using three processes: “long-scale” and “short-scale” density variations and “refrozen layers”. Consistency with this description is observed in the dynamic range of airborne 0.5–2 GHz brightness temperatures and snow radar echo peaks in measurements performed in Greenland in 2017. Based on these insights, a new analytical partially coherent model is implemented to explain the microwave brightness temperatures using the three-scale description of the firn. Short- and long-scale firn processes are modeled as a 3D continuous random medium with finite vertical and horizontal correlation lengths as opposed to past 1D randomly layered medium descriptions. Refrozen layers are described as deterministic sheets with planar interfaces, with the number of refrozen-layer interfaces determined by radar observations. Firn density and correlation length parameters used in forward modeling to match measured 0.5–2 GHz brightness temperatures in Greenland show consistency with similar parameters in CFM predictions. Model predictions also are in good agreement with multi-angle 1.4 GHz vertically and horizontally polarized brightness temperature measured by the Soil Moisture and Ocean Salinity (SMOS) satellite at Dome C, Antarctica. This work shows that co-located active and passive microwave measurements can be used to infer polar firn properties that can be compared with predictions of the CFM. In particular, 0.5–2 GHz brightness temperature measurements are shown to be sensitive to long-scale firn density fluctuations with density standard deviations in the range of 0.01–0.06 g cm−3 and vertical correlation lengths of 6–20 cm.
4 December 2020 in IEEE Transactions on Geoscience and Remote Sensing
The Ultra-Wideband Software Defined Microwave Radiometer (UWBRAD) is a wideband radiometer operating from 0.5 to 2 GHz for remote sensing of polar ice sheet temperature profiles. Small-scale (cm to m) fluctuations in firn density in the upper portion of the ice sheet significantly impact observed brightness temperatures. Previously, a fully coherent model based on solving Maxwell’s equations for thousands of layers throughout the entire ice sheet was developed. Density profiles in the model are described as the sum of a smooth average density profile with a spatially correlated random process that represents density fluctuations. In this article, we develop a “partially coherent” implementation of the coherent model that captures the impact of variations in ice density on predicted brightness temperatures while improving computational efficiency. The partially coherent model divides the ice sheet into blocks. Within each block, the coherent model is applied to take into account coherence among the contributions of closely spaced layers. A Monte Carlo procedure is used to calculate the average block reflection and transmission parameters. Between adjacent blocks, interactions are assumed to be incoherent, and the radiative transfer theory is used to incoherently cascade block parameters. Results of the partially coherent model are in good agreement with the fully coherent model and also with Soil Moisture Ocean Salinity (SMOS) and UWBRAD brightness temperature observations.
5 September 2024 in IEEE Transactions on Geoscience and Remote Sensing
Full wave simulations of the effective permittivity of firn aquifer and wet snow at L Band are reported. The Monte Carlo simulations are carried out for bicontinuous media embedded in a sphere and the scattering cross section and absorption cross section are calculated. By averaging over realizations, the effective permittivity is extracted by comparing with Mie solutions. The simulations are validated by using three numerical methods of 3D solutions of Maxwell equations: Finite difference Frequency domain (FDFD), Finite element method (FEM) and the discrete dipole approximation (DDA). Full wave simulation results are compared with those from the classical Maxwell Garnett and Polder van Santen mixing formulas. The results show large differences from mixing formulas when there are large permittivity contrasts between the background medium and the scatterers which are scenarios in aquifer and wet snow. The significance of these results is examined for the L-band microwave remote sensing of terrestrial wet snow and aquifer in polar regions.
A new time-domain technique for an accurate and fast measurement of the resonant frequency and..-factor of resonators is presented. In this technique, the phase slope with respect to frequency of a resonator is characterized and used to specify its..-factor and resonant frequency. To measure the phase slope, a slow-rate linear chirp signal is generated and passed through the resonator under test. The output signal is amplified and subsequently divided into two equal parts which are delayed by different amounts. Due to the linear time-frequency relationship of the chirp signal, the instantaneous frequencies of the two delayed signals are slightly different at any given time, and their phase difference can determine the resonator’s phase slope. Detailed analysis of the proposed approach is presented and its accuracy is verified through simulations and measurements. Based on the measured results, the proposed approach characterizes the resonant frequency and..-factor by less than 0.6% and 4% error, respectively.