To effectively apply various soil types for embankments, understanding their compaction characteristics is crucial. One crucial factor affecting compaction is suction, which plays a significant role as it is typically performed under unsaturated conditions. Suction varies with soil density, water content, and fines content. This study directly measures suction after soil compaction using the triaxial apparatus, unlike the Soil water characteristic curve (SWCC), assessing its impact on compaction characteristics. Immediate suction measurement after compaction provides apparent suction, resembling on-site conditions with open pore air pressure. Comparing SWCC with apparent suction at each compacted state reveals that suction and air entry value increase with initial density, positively impacting compaction. Notably, apparent suction aligns better with wetting process suction from the SWCC due to added water during specimen preparation. Empirical equations are derived to obtain suction contours across various density and saturation ranges, aiding in understanding suction variations on the compaction curve. Even slight variations in saturation causes noticeable changes in apparent suction during higher compaction efforts, affecting soil compaction characteristics. Therefore, the precise control of saturation control is needed to achieve desired properties of compacted soil, especially at higher compaction efforts and with various soil types. This understanding significantly impacts the mechanical behavior of unsaturated soils.
2 January 2024 in International Journal of Geotechnical Engineering
Different waste materials, such as fly-ash and bottom-ash, slag waste and construction and demolition waste have been extensively studied to replace depleting natural granular materials for fill applications. Waste foundry sand (WFS), a by-product from the aluminium metal-casting industry, is one such waste material that can be a viable fill material. In the current study, extensive large-scale model experimental tests were carried out on geogrid-reinforced WFS beds to understand their load–settlement behaviour. Basic characterisation studies on WFS included gradation, specific gravity, morphology, chemical composition and compaction testing. During large-scale model experimental testing, the geogrid reinforcement was placed at an optimum placement depth, and the maximum improvement in the load-carrying capacity of the footing resting on the reinforced WFS layer was quantified in terms of bearing capacity ratio (BCR). The BCR of reinforced WFS beds was found to be in the range of 1.3–2.0 based on the test conditions considered in the study. The reduction in the settlement of footing on reinforced WFS beds was also quantified. Additionally, the environmental impact of using WFS in reinforced foundation beds was assessed through leachate tests. The dissolved metal concentrations from leachate studies were found to be within permissible limits.
Temperature variations, within the typical range experienced in temperate climates, have been shown to influence the shear strength of clay soils, with the effect depending on factors such as soil mineral composition, confining stress, and shear rate. Seasonal temperature fluctuations and long-term climatic trends propagate from the atmosphere into the subsurface, attenuating and lagging with depth. In the upper few meters, where landslides frequently occur, seasonal temperature variations of 2–5 °C are common.We present field monitoring data from the Dubičná landslide, a slow-moving, clay-rich (primarily illitic) roto-translational slide in the Czech Republic. The landslide exhibits displacement rates of a few millimetres per year and displays a seasonal pattern not entirely attributable to precipitation trends. Using ring-shear experiments on shear-zone samples, we investigated the influence of temperature on the residual shear strength under different conditions. A linear relationship between temperature and shear strength was identified, indicating mild strengthening at higher temperatures under low shear rates.Slope stability analyses, incorporating air and subsurface temperature data, were performed for current temperature conditions and future projections under climate change scenarios. The results indicate that temperature effects on the factor of safety are modest, with a slight stabilising influence due to thermal strengthening. However, fully understanding the role of temperature in the stability of clay slopes requires further experiments and advanced modelling to account for the complexities of thermo-hydro-mechanical coupling and atmosphere-ground interactions.