The stochastic weather generator CLIGEN can simulate long-term weather sequences as input to WEPP for erosion predictions. Its use, however, has been somewhat restricted by limited observations at high spatial–temporal resolutions. Long-term daily temperature, daily, and hourly precipitation data from 2405 stations and daily solar radiation from 130 stations distributed across mainland China were collected to develop the most critical set of site-specific parameter values for CLIGEN. Ordinary kriging (OK) and universal kriging (UK) with auxiliary covariables, i.e., longitude, latitude, elevation, and the mean annual rainfall, were used to interpolate parameter values into a 10 km×10 km grid, and the interpolation accuracy was evaluated based on the leave-one-out cross-validation. Results showed that UK generally outperformed OK. The root mean square error between UK-interpolated and observed temperature-related parameters was ≤0.88 ∘C (1.58 ∘F). The Nash–Sutcliffe efficiency coefficient for precipitation- and solar-radiation-related parameters was ≥0.87, except for the skewness coefficient of daily precipitation, which was 0.78. In addition, CLIGEN-simulated daily weather sequences using UK-interpolated and observed parameters showed consistent statistics and frequency distributions. The mean absolute discrepancy between the two sequences for temperature was <0.51 ∘C, and the mean absolute relative discrepancy for solar radiation, precipitation amount, duration, and maximum 30 min intensity was <5 % in terms of the mean and standard deviation. These CLIGEN parameter values at 10 km resolution would meet the minimum data requirements for WEPP application throughout mainland China. The dataset is available at http://clicia.bnu.edu.cn/data/cligen.html (last access: 20 May 2021) and https://doi.org/10.12275/bnu.clicia.CLIGEN.CN.gridinput.001 (Wang et al., 2020).
The soil water characteristic curve is highly related to soil physical characteristics, which may be affected by the soil erosion degree. To explore the applicability of the soil moisture characteristic curve model in northeastern China, two erosion degrees, (1) lightly and (2) severely eroded black soil sampled from 15 sites, were collected. The soil water contents at eight soil water suctions were measured and the parameters of the Van Genuchten (VG) model were estimated. Then, two input sets—SSCBD (sand, silt and clay percentages and bulk density) and SSCBDθ33θ1500 (SSCBD, and water contents at 33 and 1500 kPa suction) based on the Rosetta model were compared for the VG model prediction. The results showed that the parameters in the VG model had significant difference under the two eroded soils of the saturated water content (), but the opposite was true for the residual water content (), the scale parameter () and the shape parameter (). In addition, the and had no significant differences but the opposite was true for the and under the two input sets. The simulated soil water content values of the VG model parameters derived from the Rosetta model underestimated the measured ones, except the water contents at 0 kPa. Therefore the relationships between m and n were modified for accuracy. The validation results showed that the VG model performed well when the sand content was less than 80% for the input set of SSCBD. Using the input set of SSCBDθ33θ1500 can lead to higher simulation accuracy and wider applicability compared with SSCBD under black soil.