Although existing 3D object-detection methods have achieved promising results on conventional datasets, it is still challenging to detect objects in data collected under adverse weather conditions. Data distortion from LiDAR and cameras in such conditions leads to poor performance of traditional single-sensor detection methods. Multi-modal data-fusion methods struggle with data distortion and low alignment accuracy, making accurate target detection difficult. To address this, we propose a multi-modal object-detection algorithm, Snow-CLOCs, specifically for snowy conditions. In image detection, we improved the YOLOv5 algorithm by integrating the InceptionNeXt network to enhance feature extraction and using the Wise-IoU algorithm to reduce dependency on high-quality data. For LiDAR point-cloud detection, we built upon the SECOND algorithm and employed the DROR filter to remove noise, enhancing detection accuracy. We combined the detection results from the camera and LiDAR into a unified detection set, represented using a sparse tensor, and extracted features through a 2D convolutional neural network to achieve object detection and localization. Snow-CLOCs achieved a detection accuracy of 86.61% for vehicle detection in snowy conditions.

Convolutional neural networks have achieved good results in target detection in many application scenarios, but convolutional neural networks still face great challenges when facing scenarios with small target sizes and complex background environments. To solve the problem of low accuracy of infrared weak target detection in complex scenes, and considering the real-time requirements of the detection task, we choose the YOLOv5s target detection algorithm for improvement. We add the Bottleneck Transformer structure and CoordConv to the network to optimize the model parameters and improve the performance of the detection network. Meanwhile, a two-dimensional Gaussian distribution is used to describe the importance of pixel points in the target frame, and the normalized Guassian Wasserstein distance (NWD) is used to measure the similarity between the prediction frame and the true frame to characterize the loss function of weak targets, which will help highlight the targets with flat positional deviation transformation and improve the detection accuracy. Finally, through experimental verification, compared with other mainstream detection algorithms, the improved algorithm in this paper significantly improves the target detection accuracy, with the mAP reaching 96.7 percent, which is 2.2 percentage points higher compared with Yolov5s.

In this paper, we propose a new filtering switch with excellent working performance made using an optimized coupled microstrip line. Upon analyzing the RF (radio frequency) front-end’s system structure, the switching device was simplified to a diode, which was connected to the microstrip circuit we designed to become a filter switch with both filtering and shutdown functions. First, we obtained an equivalent schematic of this filtering switch based on the relevant microstrip line theory. This switch consists of two coupled microstrip circuits, parallel-coupled feed lines and coupled-line stub-load resonators (CLSs), and a PIN diode. Second, the operating principle is described by the switching of the operating states, with ideal shutdown performance in the off state and considerable selectivity and excellent out-of-band rejection performance in the filtered state. Finally, a prototype filtering switch with a center frequency of 0.8 GHz was designed and tested. After subsequent optimization and improvement, the simulation and test performance results were noticeably consistent, consequently verifying the performance requirements of this filtering switch in two operating states in the center frequency band.

Three-dimensional object detection technology is an essential component of autonomous driving systems. Existing 3D object detection techniques heavily rely on expensive lidar sensors, leading to increased costs. Recently, the emergence of Pseudo-Lidar point cloud data has addressed this cost issue. However, the current methods for generating Pseudo-Lidar point clouds are relatively crude, resulting in suboptimal detection performance. This paper proposes an improved method to generate more accurate Pseudo-Lidar point clouds. The method first enhances the stereo-matching network to improve the accuracy of Pseudo-Lidar point cloud representation. Secondly, it fuses 16-Line real lidar point cloud data to obtain more precise Real Pseudo-Lidar point cloud data. Our method achieves impressive results in the popular KITTI benchmark. Our algorithm achieves an object detection accuracy of 85.5% within a range of 30 m. Additionally, the detection accuracies for pedestrians and cyclists reach 68.6% and 61.6%, respectively.