Digitalization is leading the development direction of oilfields in the future. And the precise measurement of produced fluids is the core component supporting the construction of digital oilfields. To mitigate the adverse effects of liquid carryover from gas wells on metering devices at the wellhead, this paper proposed a compact tandem-type gas–liquid separator structure (CTGLS) based on the principle of cyclone separation. The internal flow field characteristics and separation performance of the gas–liquid separator were analyzed through numerical simulation and experimental methods. The influence of various liquid concentrations, inlet flow rates, and overflow split ratios on the velocity field, medium distribution, and separation efficiency of gas–liquid separators was obtained. The optimal regulatory relationship of the underflow split ratio under different operating parameters was elucidated. The results indicate that, as the liquid concentration increases, the axial velocity changes significantly within the underflow region of the secondary separator, while the liquid volume fraction in the cyclone chamber increases gradually. Increasing the inlet flow rate and the split ratio can enhance the axial velocity at the overflow outlet, but it will reduce the liquid phase separation efficiency. The mathematical model correlating the operating parameters with the separation efficiency was established using the response surface method. And the best operation regulation mechanism of the split ratio was obtained under different inlet flow rates and liquid concentrations.

The engine casing components operate in high-temperature and high-pressure environments. Process holes are drilled when defects occur. Welding is employed in the repair of process holes as a process for permanently joining materials. The traditional welding method relies on padding, which results in poor back formation of process holes. Additionally, the shape of the process holes imposes high requirements on the size of the droplet transition. The conventional approach of adjusting a welding current makes it difficult to achieve stable droplet transition and precise formation of small holes. It poses a challenge for the robotic welding process. To deal with this problem, the influence of the high-frequency vibration GTAW process on the directional transition of molten droplets is studied. The molten droplet directional transition process is developed. The impact of vibration energy on the molten pool is reduced. Welding repair experiments for process holes are successfully conducted. When the frequency is 3 Hz, the transition of droplets changes from a continuous one-droplet transition to a discontinuous liquid bridge transition. The residual height and mechanical properties of the repaired area are tested. The experimental results indicated that the residual height after dual-side repair is ≤0.7 mm. The X-ray and fluorescent penetration tests have a 100% first-pass qualification rate. The repaired area demonstrates a hardness of 480 HV and a room-temperature tensile strength of 1069 MPa. The repair process requirements for the casing are met.

In order to remove oil and suspended solid in oilfield wastewater, Takacs model was improved and applied to the simulation of oil floating, the parameters of oil coagulation velocity were added. By this model, the accurate oil floating model and sludge sedimentation model were established. On the basis of this model, the experimental verification was carried out by the sample from the wasted water station. By the response surface method, the influence of flow rate, treatment fluid concentration and settling time and their interaction on oil removal rate and suspension removal rate were studied, and the important influence of time factor was determined. According to the pollution degree of oil field wasted water, based on the theory and experimental method of this paper, the treatment capacity and settling time of oil field wasted water could be optimized, which provides theoretical guidance for the improvement of settlement device and the industrial application in the oilfield.