In an effort to overcome the problem that the traditional stochastic resonance system cannot adjust the structural parameters adaptively in bearing fault-signal detection, this article proposes an adaptive-parameter bearing fault-detection method. First of all, the four strategies of Sobol sequence initialization, exponential convergence factor, adaptive position update, and Cauchy–Gaussian hybrid variation are used to improve the basic grey wolf optimization algorithm, which effectively improves the optimization performance of the algorithm. Then, based on the multistable stochastic resonance model, the structure parameters of the multistable stochastic resonance are optimized through improving the grey wolf algorithm, so as to enhance the fault signal and realize the effective detection of the bearing fault signal. Finally, the proposed bearing fault-detection method is used to analyze and diagnose two open-source bearing data sets, and comparative experiments are conducted with the optimization results of other improved algorithms. Meanwhile, the method proposed in this paper is used to diagnose the fault of the bearing in the lifting device of a single-crystal furnace. The experimental results show that the fault frequency of the inner ring of the first bearing data set diagnosed using the proposed method was 158 Hz, and the fault frequency of the outer ring of the second bearing data set diagnosed using the proposed method was 162 Hz. The fault-diagnosis results of the two bearings were equal to the results derived from the theory. Compared with the optimization results of other improved algorithms, the proposed method has a faster convergence speed and a higher output signal-to-noise ratio. At the same time, the fault frequency of the bearing of the lifting device of the single-crystal furnace was effectively diagnosed as 35 Hz, and the bearing fault signal was effectively detected.

In light of the problem of difficult model parameter selection and poor resonance effects in traditional bearing fault detection, this paper proposes a parameter-adaptive stochastic resonance algorithm based on an improved whale optimization algorithm (IWOA), which can effectively detect bearing fault signals of rotating machinery. First, the traditional WOA was improved with respect to initial solution distribution, global search ability and population diversity generalization, effectively improving the global convergence of the WOA. Then, the parameters of the bistable stochastic resonance model were optimized using the improved WOA, and adaptive adjustment of the stochastic resonance parameters was realized. Finally, the Case Western Reserve University bearing data set and the XJTU-SY bearing data set were used as fault data for the actual bearing to be tested for experimental verification. The signal-to-noise ratios of the detected fault frequencies for the above two data sets were −20.5727 and −21.1289, respectively. Among the algorithms compared, the IWOA proposed in this paper had the highest signal-to-noise ratio of the detected fault frequencies. The experimental results show that the proposed method can effectively detect a weak bearing fault signal in enhanced noise.

Aiming at the poor effect of traditional denoising algorithms on image enhancement with strong noise, an image denoising algorithm based on improved whale optimization algorithm and parameter adaptive array stochastic resonance is proposed in the paper. In this algorithm, through dimensionality reduction scanning, coding, modulation and other processing, the noise-containing gray image becomes a one-dimensional aperiodic binary pulse amplitude modulation signal suitable for a bistable stochastic resonance model. Then, the traditional whale optimization algorithm is improved in the initial solution distribution, global search ability and population diversity generalization. The improved whale optimization algorithm is applied to select the parameters of the stochastic resonance, which effectively improves the parameters self-adaptive of the array stochastic resonance model. Finally, the denoised image is obtained by demodulating, decoding and anti-scanning the stochastic resonance output. The experimental results show that compared with the array stochastic resonance method with fixed parameters and the classical image denoising method, the algorithm proposed in this paper has better performance in terms of visual effect and peak signal-to-noise ratio index, which proves the advantages and effective application of the method in image denoising.