A fiber Bragg grating (FBG)-based aluminum oxide tube packed sensor (ATPS) was developed for the fast detection of the soil moisture profile in highway slopes and subgrades. The novel ATPS consists of an aluminum oxide tube with a diameter of 5 mm, an optical fiber containing a quasi-distributed FBG sensors, a “U”-shaped resistance wire, and a flange. There are four 0.9-mm diameter holes in the ATPS. Laboratory experiments were carried out to calibrate the relationship between the thermal response of ATPS and the soil moisture content. Two laboratory rainfall validation model tests were performed to validate the ATPS for capturing the soil moisture profile in highway slopes and subgrades. During the validations, the accuracy of the ATPS was quantified, and water infiltration through grassy and grassless ground surfaces were investigated. The calibrations indicate that the ATPS can detect and record real-time changes in the highway slope and subgrade moisture after rainfall, and reveal the most dangerous zones that occur at the connection between different construction materials. The average measurement accuracy of soil moisture monitoring was 0.015 m³/m³. Please note that the connection is where cracks form easily and the soil hydraulic conductivity increases significantly. The test results also indicate that grassy cover (lawn) significantly prevents water infiltration during the first few minutes of rainfall (twelve minutes in this study), after which, however, the infiltration rate drops sharply. The influence of lawn on water infiltration depends on the soil structure, hydraulic conductivity, and rainfall time. In summary, due to its small size and fast detection, the ATPS is a portable probe that can be used for moisture monitoring in highway slopes and subgrades.

Mastering the strain transfer mechanism in distributed fiber optic (DFO) sensors holds the key to analyzing strain measurement errors from DFO sensing systems. However, the impact of the monitored structure’s strain distribution on the strain transfer mechanism in DFO sensors has often been overlooked in the existing research. To address this issue, a strain transfer model of surface-bonded DFO sensors with multilayered structures was established based on the shear lag theory. The closed-form solutions of the strain transfer coefficient of DFO sensors subjected to uniform, parabolic, single-linear gradient, and bilinear gradient strains were obtained. With a high-accuracy optical frequency-domain reflectometer (OFDR), the theoretical model was validated by laboratory tests. Upon parametric analysis, suggestions were further offered about designing and installing DFO sensors.

Large-scale measurements of soil moisture play a critical role in many fields, such as agriculture, hydrology, and engineering. The distributed temperature sensing (DTS) technology, based on a dual-probe heat pulse (DPHP), is a novel approach to realizing large-scale soil moisture estimation. However, the application of the method is limited by the complex optical cable layout, calculation algorithm, and lack of standardized heating strategy. In this paper, an improved DPHP-DTS method considering the soil bulk density was proposed. The measurement accuracy of the DPHP-DTS method under different heating strategies was studied in laboratory experiments, and its long-term stability in regard to the monitoring of soil moisture during natural evaporation in different soils was tested. The results show that the improved DPHP-DTS method can accurately measure the soil moisture, and the fitting algorithm can reduce the error caused by the accuracy of the DTS temperature measurement under the low-power heating strategy. Its measurement accuracy increases with the increase in the heating strength and duration. In addition, the improved DPHP-DTS method can describe soil evaporation in both sand and loess with good reliability and stability.