In this work, a three-dimensional unsteady heat transfer model of base bleed unit with trilobite ammonium perchlorate (AP)/hydroxyl-terminated polybutadiene (HTPB) composite solid propellant is presented to analyze the cook-off characteristics. According to the two-step chemical reaction of AP/HTPB propellant, a small-scale cook-off test is established. A comparison of the experimental and calculated results is made to verify the rationality of the computation model. On this basis, a cook-off numerical simulation of the base bleed unit at the heating rates of 0.33, 0.58 and 0.83 K/s is presented to investigate the ignition and initiation characteristics. The results show that the ignitions occur on the head face of the AP/HTPB propellant and near the internal gas chamber in these conditions. As the heating rate increases, the runaway time decreases and the ignition temperature rises.
29 July 2022 in Journal of Mechanical Science and Technology
The characteristics of burning jets of magnesium/polytetrafluoroethylene (MT) pyrotechnic base bleed igniter in the atmosphere are studied by a high-speed camera (HSC) combined with the infrared thermal imager (ITI) for MT igniters with different mass ratios. A 3D steady combustion model is established based on the simplified three-step chemical kinetic mechanism. Finite volume method (FVM) is applied to the numerical simulation of the time-averaged combustion field using a RANS two-equation eddy viscosity model coupled with the eddy dissipation concept (EDC) model. The results indicate that the highest temperature region in the combustion field is located above the potential core of each single jet, corresponding to the most intense chemical reaction region, whereas the maximum velocity region is located on the perimeter side of the potential core. In the converging region, the momentum, heat, and components Mg, MgF2, and C2 transfer and diffuse rapidly from each burning jet to the centerline of the combustion field, except that the component C2F4 is consumed completely in and around the potential core. However, in the combined region, the temperature, velocity, and concentration of each component all reach the maximum on the central axis of the combustion field. Simultaneously, the similarity of cross sections is shown. An increase in the concentration of Mg in the range of 0.45–0.61 occurs, and the reaction rate and reaction heat decrease, so that the temperature and velocity of the combustion flow decay and the gradient are also reduced. In addition, the mass fractions of C2F4, MgF2, and C2 decrease.