The aerodynamic performance of inverted wings on racing-car configurations is most critical when cornering; however, current wind tunnel techniques are generally limited to the straight-line condition. The true cornering condition introduces complexity because of the curvature of the freestream flow. This results in an increase in the tangential velocity with increasing distance from the instantaneous centre of rotation and causes the front wing to be placed at a yaw angle. Numerical simulations were used to consider an 80% scale front wing when steady-state cornering with radii ranging from 60 m to 7.5 m, and yaw angles ranging from 1.25° to 10°. The changes to the pressure distribution near the endplates caused the wake structure to become highly asymmetric. Both the primary longitudinal vortices and the secondary longitudinal vortices differed in strength, and the vortex core positions shifted in the vertical direction and the spanwise direction. The change in the position became more substantial further downstream as the structures tended toward the freestream direction. The effects on the wing surface pressure distribution resulted in the introduction of yawing and rolling moments, as well as a side force and an increase in drag. The results demonstrate the importance of evaluating the cornering condition if that is where a good performance is most sought after.
18 January 2012 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
A computational fluid dynamics study of the influence of wing span has been conducted for an inverted wing with endplates in ground effect. Aerodynamic coefficients were determined for different spans at different ground clearances, highlighting a trend for shorter spans to delay the onset of both separation and resulting loss of negative lift. The vortices at the wing endplates were not observed to change significantly in terms of strength and size; thus, at shorter spans, their influence over a larger percentage of the wing helped the flow stay attached and reduced the severity of the adverse pressure gradient which invokes separation at greater spans. Consequently, it was shown that, compared to a large-span wing, a wing with a shorter span may have a lower lift coefficient but can operate closer to the ground before performance is adversely affected.
When a vehicle travels through a corner it can experience a significant change in aerodynamic performance due to the curved path of its motion. The yaw angle of the flow will vary along its length and the relative velocity of the flow will increase with distance from the central axis of its rotation. Aerodynamic analysis of vehicles in the cornering condition is an important design parameter, particularly in motorsport. Most racing-cars are designed to produce downforce that will compromise straight-line speed to allow large gains to be made in the corners. Despite the cornering condition being important, aerodynamicists are restricted in their ability to replicate the condition experimentally. Whirling arms, rotary rigs, curved test sections and bent wind tunnel models are experimental techniques capable of replicating some aspects of the cornering condition, but are all compromised solutions.Numerical simulation is not limited in the same way and permits investigation into the condition. However, cornering introduces significant change to the flowfield and this must be accommodated for in several ways. Boundary conditions are required to be adapted to allow for the curved flow occurring within a non-inertial reference frame. In addition, drag begins to act in a curved path and variation in Re occurs within the domain. Results highlight the importance of using correct analysis techniques when evaluating aerodynamic performance for cornering vehicles.