Experimental verification is used to show that reference specimens and structure unloading do not permit obtaining an adequate estimate of plastic strain by measuring the acoustic anisotropy. Analytic estimates of the speed of propagation of a plane acoustic wave of various polarizations in an elastoplastic material in the direction orthogonal to the action of preliminary uniaxial stress are obtained. An analysis of the obtained relations reveala an advantage of using absolute values of the velocity of longitudinal and transverse waves for the plastic strain identification. In contrast to acoustic anisotropy, the velocities vary monotonically in a wider range of plastic strains. At the same time, the elastic strain does not affect the longitude wave velocity, which allows one to use the measurement results to estimate the character of strains.
The mechanisms of densification in spark plasma sintering (SPS) were investigated both analytically and numerically for a model system of two spherical metallic powder particles. From the microscopic temperature distribution, the possibility of a micro-local overheating of the particle–particle contacts was analysed for different particle sizes, contact geometries, materials, and electrical loads. It is shown that, for particles below the size of one millimetre, local overheating is below one Kelvin. Subsequently, the material transport by thermomigration, electromigration, and diffusion driven by surface curvature and external pressure was derived from microscopic field distributions obtained from analytical calculations and finite-element simulations. The results show that, while the mechanical pressure accelerates material transport by orders of magnitude, the electrical current and the temperature gradients do not. It is also shown that pulsing the current has no significant influence on the densification rate.
The mechanisms of densification during spark plasma sintering (SPS) of spherical copper particles are investigated both experimentally and analytically. Experimentally measured densification rates are compared to expected contributions to densification coming from Coble creep, Nabarro-Herring creep, power-law creep, and pressure-assisted sintering described by the two-particle model. The results indicate densification by Coble creep or a low-temperature version of power-law creep in the investigated range of temperature and pressure at a relative density of 70%. The findings are supported by (i) activation energies obtained for various conditions using the Dorn-method as well as (ii) the pressure dependence of the densification rate.