One of the main error sources in GNSS positioning comes from the ionosphere, an atmospheric layer that stays in the signal path between the satellite and the receiver. For single frequency positioning, the ionospheric effects can be minimized by using an ionospheric model e.g. Klobuchar or NeQuick G. These models are respectively associated to GPS and Galileo systems through their navigation messages, which broadcast coefficients that describe the worldwide ionospheric behavior, and the calculated ionospheric delay is then applied in the pseudorange observations. In this paper, it is presented a comparison between these two models in multi-GNSS (GPS and Galileo) single frequency point positioning, considering two Brazilian stations at different magnetic latitudes, and covered months of weak and strong ionospheric activity from 2013 to 2018. The results indicate a better performance of NeQuick G model compared to the Klobuchar. Considering all the analyzed periods and stations, Klobuchar improves the positioning accuracy in 16% and 50% in periods of weak and strong ionospheric activity, respectively, while NeQuick G improves the accuracy in 31% and 55%.
The vertical total electron content (VTEC) is one of the key quantities to describe variations of the ionosphere and can be provided to users to correct the ionospheric disturbances for GNSS (Global Navigation Satellite System) positioning. The VTEC values and the corresponding standard deviations are routinely provided in the so-called Global Ionosphere Maps (GIM), with a typical time resolution of 2 h (and up to 15 min) on regular grids with 2.5º resolution in latitude and 5º resolution in longitude. To determine the ionospheric corrections from the GIMs for positioning applications, an interpolation has to be applied to the VTEC grid values, which generally degenerates the final VTEC accuracy. In this context, the typically applied bi-linear interpolation of the VTEC values is calculated by introducing a new weighting scheme by means of the standard deviation maps in the ionospheric domain. In the sequel, the impact of the use of the VTEC uncertainties for the interpolation procedure is applied to the GIMs of different centers and assessed in the ionospheric and in the positioning domain. For the assessment of the GIM in the ionospheric domain, the VTEC values calculated are compared with VTEC directly obtained from the given GIM, i.e., without interpolation. In the positioning domain, the impact of the VTEC uncertainties is analyzed by means of single-frequency precise point positioning (PPP), considering four Brazilian stations in challenging regions. The use of the standard deviation values in positioning provides a significant improvement in periods of high solar flux, especially for stations in the region under more intense ionospheric effect (mean rates of improvements up to 47%).
30 December 2020 in Revista Brasileira de Cartografia
GNSS (Global Navigation Satellite Systems) have gained a lot of visibility in the last two decades, being currently applied in several activities that go far beyond navigation positioning, some of them requiring high precision (centimeter to millimeter), such as structural monitoring and precision agriculture. To meet these requirements, different positioning methods have been developed, such as (standard and precise) point positioning and relative positioning. More recently, the possibility real time positioning with the use of networks has emerged, both for point and relative methods. The launch of new global constellations has enabled the integration of the different systems which, when successful, offers improvements for the positioning regarding the availability of satellites, the geometry between the receiver and the satellites, ambiguity resolution and its performance when compared to the isolated use of systems. In this sense, this paper presents a review and state of the art of the main characteristics of the four global systems and the different positioning methods, highlighting the multi-GNSS integration, trends and challenges in each of them. Results comparing multi-GNSS with the four constellations positioning to GPS-only, using a 25° cutoff angle, simulating an obstructed environment, are also presented. Considering the positioning accuracy, which considers the error and standard deviation in the position estimate, the integration of the systems brought an improvement of up to 44%.
1 June 2020 in Journal of Atmospheric and Solar-Terrestrial Physics
Carrier phase and code observable are used in high accuracy positioning by global navigation satellite systems. However, the carrier phase measurement may suffer cycle slip during signal tracking. Cycles slip is a discontinuity of an integer number of cycles in the phase observable, caused by a temporary loss of lock in the receiver carrier tracking loop. Thus, cycles slip must be detected and corrected in order to obtain accurate positioning. In the present article, is proposed the definition of a new threshold of accept the cycle slip occurrence based on the values of mean and standard deviation of triple difference (TD) series data when using the detection and correction TD method. The experiments were performed with simulated data for short baseline and long baseline. For short baseline data, the classical TD method and the proposed TD method presented similar results, around 100% accuracy in the detection. For the long baseline data, 31.37% and 63.79% of detection accuracy were obtained, resulting in 49.45% and 95.32% accuracy in the correction of cycles slip when using the classical TD method and the proposed TD method. These results indicate that the proposed method is relevant in the context of detection and correction of cycle slip, especially for long baselines, as is the case in Brazil.
28 October 2020 in Revista Brasileira de Geomática
O Galileo é a contribuição da União Europeia ao GNSS (ingl. Global Navigation Satellite Systems – Sistemas de Navegação Global por Satélite) e está próximo da declaração da fase operacional completa, que deve ocorrer no final de 2020 ou início de 2021. Este sistema começou a ser concebido na década de 90, após a decisão do governo americano em não permitir que outras nações participassem da construção e manutenção do sistema NAVSTAR – GPS (ingl. Global Positioning System – Sistema de Posicionamento Global). O sistema Galileo é a primeira contribuição civil para o GNSS e foi desenvolvido de forma a ser independente dos outros sistemas nos segmentos espacial, de controle e operacional. Além disso, está sendo desenvolvido para ser interoperável e compatível com os outros GNSS, em especial o GPS. Nos últimos anos, o desenvolvimento do Galileo fez progressos significativos. A constelação atual compreende um total de 26 satélites orbitando a Terra, 22 operacionais, dos quais três pertencentes à primeira geração de satélites de validação de órbita, e a infraestrutura de controle terrestre está em pleno funcionamento. Para o usuário, são transmitidos sinais em três frequências E1, E5 e E6. Os sinais em E1 e E5 são transmitidos nas mesmas frequências que os sinais GPS L1 e L5 e ambos sistemas usam princípios de modulação equivalentes. Isso é benéfico pois proporciona uma melhor cobertura e maior robustez para usuários que podem utilizar os sistemas de forma combinada. Além disso, o Galileo oferece vários novos serviços específicos, como o serviço aberto, o serviço de alta acurácia e de busca e resgate. Como o sistema Galileo está atualmente em fase final de implantação, faz-se necessário na literatura brasileira, um artigo que trate exclusivamente desse sistema, este artigo apresenta o estado da arte do sistema Galileo (julho de 2020). Resultados iniciais demonstraram que o Galileo tem acurácia comparável ao GPS, no posicionamento por ponto simples.