Transparent conductive films (TCFs) based on rectangularly shaped silver nanowires (AgNWs) with different width-to-height ratios were theoretically studied. We show that tall AgNWs (height > width) possess higher transmittance and lower sheet resistance compared to other configurations of AgNWs. Moreover, tall AgNWs possesses significantly higher optical haze, which makes them a transparent conductor of choice for thin solar cell applications. For applications requiring low haze such as displays and touch screens, we propose an updated figure of merit embodying transmittance, sheet resistance and haze, allowing tuning width-to-height ratio to achieve a reasonable AgNW TCF performance trade-off. Obtained results offer a means for deeper analysis of AgNW properties for many optoelectronic applications.
1 June 2011 in SID Symposium Digest of Technical Papers
Near-infrared transparent electrodes constitute an essential component of light-emitting and photovoltaic devices widely employed in short- and long-range communication, light detection and ranging, biodiagnostics, security, virtual and augmented reality, night vision, gas sensing, and solar cells. However, the efficiency of all these devices and related applications suffers from significantly reduced transmittance of the indium tin oxide electrode compared to the visible wavelength range. Here, we explore the potential of randomly and uniformly arranged silver, gold, and aluminum nanopore and nanowire films for the near-infrared optoelectronics. We show that these metallic nanopatterned layers, except for randomly arranged nanoporous configurations, exhibit considerably higher performance than the commonly used indium tin oxide. Furthermore, silver layers possess higher transmittance and lower haze than gold and aluminum ones, while the nanowire configuration overperforms the nanoporous one. The obtained results offer a means for deeper analysis of metallic nanopatterned transparent electrodes for many near-infrared optoelectronic applications.
Optoelectronic performance of nano-/microscale porous and wired silver (Ag) and aluminum (Al) layers was theoretically studied. Within the nanoscale region, Ag porous and wired layers – possessing stronger surface plasmon response over the whole visible spectrum –demonstrate up to a 20% higher average transmittance in comparison to identic Al design. In the microscale region, difference in the average transmittance between the above mentioned metallic layers decreases to 5%. Moreover, the microscale Ag and Al layers exhibit up to a 5% higher average transmittance. The obtained results allow deeper analysis of the pattern scale of metallic transparent conductive layers for various optoelectronic applications, such as displays, solar cells, light-emitting diodes, touch screens and smart windows.
Ultra-thin solar cells enable materials to be saved, reduce deposition time, and promote carrier collection from materials with short diffusion lengths. However, light absorption efficiency in ultra-thin solar panels remains a limiting factor. Most methods to increase light absorption in ultra-thin solar cells are either technically challenging or costly, given the thinness of the functional layers involved. We propose a cost-efficient and lithography-free solution to enhance light absorption in ultra-thin solar cells—a Tsuchime-like self-forming nanocrater (T-NC) aluminum (Al) film. T-NC Al film can be produced by the electrochemical anodization of Al, followed by etching the nanoporous alumina. Theoretical studies show that T-NC film can increase the average absorbance by 80.3%, depending on the active layer’s thickness. The wavelength range of increased absorption varies with the active layer thickness, with the peak of absolute absorbance increase moving from 620 nm to 950 nm as the active layer thickness increases from 500 nm to 10 µm. We have also shown that the absorbance increase is retained regardless of the active layer material. Therefore, T-NC Al film significantly boosts absorbance in ultra-thin solar cells without requiring expensive lithography, and regardless of the active layer material.